Hunter Fan ICR owner manual Installing the SmartPort Wiring Harness

Page 8

SmartPort® Wiring Harness........................................................................

To utilize the ICR remote control system, your controller must be equipped with a SmartPort wiring harness. This wiring harness provides the communication port where the ICR receiver is attached. The SmartPort can be connected to Hunter SRC, Pro-C and ICC controllers. A SmartPort wiring harness is provided with your ICR remote system. The typical SmartPort location is approximately 12" below the controller. The recommended installation procedure for this location would be as follows:

To Controller
1/2" Thread
Pre-assembled	Assembled

Installing the SmartPort Wiring Harness.........................................

1.Install a ½" female threaded “Tee” in the field wiring conduit approximately 12" below the controller.

NOTE: The harness may be installed outdoors by bringing the conduit through an exterior wall, then installing the appropriate fitting.

2.Feed the red, white, and blue wires of the SmartPort through the base of the “Tee” and into the controller wiring compartment as shown in the following figures..

NOTE: For installations where the receiver will be installed permanently on an outside wall, make certain that the SmartPort is the version with an o-ring seal.

Image 8

Contents For Use with Hunter Controllers Installation Instructions ICRPage Table of contents TABLa de contenido Introduction ICR Components SmartPort Carrying Case TransmitterReceiver SmartPort Wiring Harness Installing the SmartPort Wiring HarnessWiring the SmartPort to hunter controllers SRC Controller SmartPort InstallationPro-C Controller SmartPort Installation Blue Red WhiteTypical Installations Preparing the Transmitter for UseTo change the Run Time Installing the Transmitter BatteriesChanging the Run Time Changing the Transmitter Address Changing the Maximum Number of StationsTo change the Transmitter address To change the Maximum Number of StationsPreparing the Receiver for Use SRC/Pro-C/ICC ControllersACC/ACC Decoder Controllers Changing the Receiver AddressActivating a Station with the ICR Remote System To remotely activate a station or programMaximizing Operating Range Troubleshooting Guide CAUSes SolutionsOperating Specifications Electrical SpecificationsDefault Settings DimensionsPage Presentación del Producto Componentes del ICR SmartPort Caja EmisorReceptor Conexión de Cableado del Programador SmartPort Instalación del Arnés de Cableado SmartPortAzul Rojo Blanco Instalación SmartPort del Programador Pro-CInstalaciones Típicas Preparación del Emisor Antes de su UsoCambio del Tiempo DEL Ciclo de Riego Cambios al Tiempos de RiegoColocación de la Pila del Emisor Modificación de la Dirección del Emisor Modificación del Número Máximo de EstacionesPara Modificar la Dirección del Emisor Para Modificar el Número Máximo de EstacionesPreparación del Receptor Antes de su Uso Programadores SRC/Pro-C/ICCModificación de la Dirección del Receptor Optimización de la Zona de Funcionamiento Guía Para Solucionar Problemas Problema Causas SolucionesDimensiones Especificaciones de OperaciónEspecificaciones Eléctricas Reglaje por fallaFCC Compliance Notice