•Press to select a mode or figure from the setting menu.
21 RECORD button– Press to start manual recording.
22 SPEED button– Press to choose the desired recording speed:SP/SLP.
23
24 GAME button– Press to set the Game mode and exter- nal input mode at the same time. (Refer to page 11.)
25
26 EJECT A button– Press in the stop mode to remove the cassette from the unit.
27 CHANNEL RETURN button– Press to go back to the previously viewed channel. Press again to return to the present channel.
28CHANNEL K/L buttons– Use to select the desired channels for viewing or recording.
TRACKING function– Use to minimize video ‘noise’ (lines or dots on screen) during playback mode. (Refer to page 18.)
29 VOLUME X/Y buttons– Adjust the volume level.
30 MUTE button– Press to mute the sound. Press it again to restore the sound.
31 PLAY / K (cursor) button–
•Press to start playback.
•Press to select a mode or figure from the setting menu.
32 F.FWD / B (cursor) button–
•Press to rapidly advance the tape or to view the picture rapidly in forward during playback mode. (Forward Search)
•Press to determine your selection and proceed to the next step in the setting menu.
33 PAUSE/STILL F button– Press to temporarily stop the tape during the recording or to view a still picture during playback.
34 TIME SEARCH button– Press to activate Time Search mode.
ANT.
35 Power cord– Connect to a standard AC outlet (120V/60Hz). (Refer to page 10.)
3536
36 ANT(ENNA). jack– Connect to an antenna, cable system or satellite system. (Refer to page 9.)
INSTALLING THE BATTERIES
1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.
2)Insert 2 “AA” penlight batteries into the battery compartment in the direction indicated by the polarity
3)Replace the cover.
[BATTERY PRECAUTIONS]
•Be sure to follow the correct polarity as indicated in the battery compartment. Reversed batteries may cause damage to the device.
•Do not mix different types of batteries together (e.g. Alkaline and
•If the device is not to be used for a long period of time, remove the batteries to prevent damage or
EN
injury from possible battery leakage.
•Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
IR SIGNAL CHECK
Use the AM radio or the digital camera to check if the remote control properly sends out the infrared signal. It will help to define the cause of malfunction.
Using AM radio
•Tune the AM radio to no broadcasting
band. Press any button on remote control toward the radio. If the radio receives the signal from remote control properly, the sound will flutter.
Using digital camera (including
• Press and hold any button on remote control toward a digital camera. The remote control is working if you confirm infrared light through the digital camera.
- 8 -