Magnavox MC192DMG Follow the instructions in to set, Recording’s stop time. AM or PM will be set

MC132DMG/MC192DMG 3/22/02 1:21 PM Page 33

4 Use the Number buttons (1-8) to select a posi- tion in which to store the timer recording. Flashing numbers indicate an open position (one in which a timer recording has not been stored yet). NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen for a few seconds. Then infor- mation about the program in that position will appear on the screen. If this happens, press the STATUS/EXIT but- ton. Then use the Number buttons to select another posi- tion.

5 Use the Number buttons to enter the channel of the TV program you want to record.

● If you are recording from line input, press 0, 0. A/V IN will appear on the screen.

● If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Timer Recording (cont’d) 33

POWERSLEEP/WAKE UP

	PLAY
REW		F.FWD
	STOP
MENU			CLEA
	STATUS/EXIT		R
1	2	3
4	5	6	CH.
7	8	9
	0	ALT.CH	VOL.
SPEED	MEMORY	PAUSE/STILL
	TRACKING		MUTE

4-7

6 Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM	1
CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Follow the instructions in step 6 to set the
recording’s stop time. (AM or PM will be set
7 automatically.)
ONE TIME PROGRAM
PROGRAM	1
CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 34.

Helpful Hints

•If you enter numbers that do not match the TV/VCR’s clock or cal- endar, the entry will be rejected and a question mark will appear on the screen.

•To make corrections while you are programming a timer record- ing, press the CLEAR button until the cursor is flashing on the item you want to change. Then enter the correct information.