Magnavox MC192DMG, MC132DMG owner manual Glossary

Page 53

MC132DMG/MC192DMG 3/22/02 1:21 PM Page 53

Glossary 53

AUDIO In Jack: jack on the front of the TV/VCR which is used to record audio from another source.

Automatic Channel Setup: process in which the TV/VCR memorizes all available channels. Then, when you push the CH(annel) o/p buttons, you only scan through channels you receive.

Bands: settings that allow you to tune channels.

•Antenna – VHF (very high frequency; channels 2-13) and UHF (ultra high frequency; channels 14-69).

•Cable – all standard channels can be received without a Cable Box.

Brightness: adjusting increases or decreases the bright- ness of the color on the screen.

Color: adjusting pales or brightens the TV/VCR color.

Dubbing: copying a tape using a VCR.

HQ: high quality; a feature in the TV/VCR circuitry which provides enhanced picture detail.

Line Input: The channel to which you set your TV/VCR during dubbing. The line input channel is always channel 00 (A/V IN).

Mode: a TV/VCR operation.

OTR: One-Touch Recording; a timed recording that starts immediately and records for 30 minutes to eight hours, whichever you specify.

Picture: adjusting increases or decreases the contrast of the picture on the screen.

Sharpness: adjusting softens or clarifies the picture on the screen.

Tape Speeds: how fast the tape travels during playback or recording.

•SP (standard play) – fastest tape speed (recording time for a T120 tape is approximately two hours); best picture quality.

•LP (long play) – average tape speed; playback only.

•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).

Tint: adjusting changes the tints of the picture on the

TV/VCR from purple to green.

VIDEO In Jack: jack on the front of the TV/VCR which is used to record video from another source.

Image 53

Contents MC132DMG/MC192DMG Model No Serial No Dear Magnavox product ownerFor Customer Use Safety Precautions FeaturesIntroduction Declaration of ConformityTable of Contents Battery Safety Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR MaintenanceHooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownRF coaxial cable Not supplied Rod AntennaCrooked Pin Straight Pin Hooking Up the TV/VCR cont’dAudio and video cables are not supplied You cannot set up channels if you are using a Cable Box Press the Power button. The TV/VCR willTurning On the TV/VCR Select another channelPress the Menu button Language SelectionPress the Menu button Press the STATUS/EXIT but TonLine Input mode Automatic Channel SetupWait for the TV/VCR to set up channels Steps Adding/Deleting ChannelsPress the CHannel o/p buttons or Repeat steps 3-4 to add or delete other channelsManual Clock Setting Setting the ClockCable Box users must set the clock manually Channels are set. Details are onButtons for the year. For example, for July Setting the Clock cont’dPM, press 09, 30 Automatic PBS Channel Selection Ton to select PRIM. SETUP. Then, pressPress the PLAY/ button or the STOP/ but- 1,4 FWD/B buttonWait for the TV/VCR to find the time NOW Searching flashes on the TV/VCR screenManual PBS Channel Selection Use the Number buttons to select your PBS station Daylight-Savings Time Clock is OFF Time ZoneFront Panel Rear Panel ANTenna Jack AC Power CordDetails are on page six To the TV/VCRRemote Control Buttons STATUS/EXIT Button Clear ButtonSTOP/ Button ALT. CH Alternate Channel ButtonWhen you finish, press the STATUS/EXIT but- ton Refer to the chart onPress the PLAY/ button or the STOP/ but Menus on page 25 will disapDecrease Increase Adjusting the Picture Controls cont’dMore brilliant Decreased brightnessIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFReminder Follow the steps below to play a tape PlayingTo stop recording, press the STOP/ button Tape Speeds Read and follow the steps below to record a TV programHrs Recording options are on pagesTape is in the TV/VCR. The record tab must be intact One-Touch RecordingTV/VCR will turn off at the end of the OTR Ton on the TV/VCR to stopRerecording Tape Duplication TV/VCR is now in Line Input modeDetails are on Timer RecordingDaily Automatically Follow the instructions in to setRecording’s stop time. AM or PM will be set If Program not Completed appears, start again at step Timer Recording cont’dYou cannot use the Speed button at this time During the power failure Checking or Clearing Timer RecordingsTUS/EXIT button Defeat RecordingFollow the steps below to prevent accidental recording TV programming will appear while the tape is rewinding Play modeRepeat Play Insert a tape in the TV/VCR B Repeat PlayInsert a tape in the TV/VCR Press the Menu button Will become a flashing B PowerCounter will appear on the screen Setting will be lostPlayback Options Still modeForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPSmartlock menu will appear Use the Number buttons to enter your access codeSmartLock SmartLock cont’d Ratings will remain blocked even after a power failureExample Specific Sub-ratings BLOCKED... message appearsUse the Number buttons to enter your desired Use the Number buttons to enter your old access codeSame code in the Confirm Code space Active code againRating Explanations Press the PLAY/o button or the STOP/p button Blue BackgroundTo select Blue BACKGROUND. Then, press FWD/B button repeatedly so that OFF or onSleep timer during a recording Sleep TimerWake Up Timer Volume Bar Menu Screen Closed Caption Example Sample Picture Half-screen text Sample Picture Standard Closed CaptionsAutomatic Operation Features Glossary Helpful Hints Helpful Hints cont’d Specifications Renewed Index MC132DMG/MC192DMG 3/22/02 121 PM Supplied Accessories