Magnavox MC132DMG Hooking Up the TV/VCR, Hook up your TV/VCR using one of the connections shown

Page 6

MC132DMG/MC192DMG 3/22/02 1:21 PM Page 6

6 Hooking Up the TV/VCR

1 Hook up your TV/VCR using one of the connections shown.

AHooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an antenna to the ANT(enna) Jack.

ANT.

ANT.

B Hooking Up Your

TV/VCR With a Cable

Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

Connect the Cable signal to the IN Jack on the Cable Box.

Connect an RF coaxial cable (75- ohm, not supplied) to the OUT Jack on the Cable Box and to the ANT(enna) Jack on the TV/VCR.

OUTIN

RF coaxial cable

(not supplied)

ANT.

ANT.

CHooking Up Your

TV/VCR With an

Indoor Antenna

To install a rod antenna (not supplied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the anten- na wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Rod Antenna

(not supplied)

ANT.

ANT.

Image 6

Contents MC132DMG/MC192DMG Dear Magnavox product owner For Customer UseModel No Serial No Introduction FeaturesSafety Precautions Declaration of ConformityTable of Contents Using the Remote Control Putting Batteries in the Remote ControlBattery Safety TV/VCR MaintenanceRF coaxial cable Not supplied Hook up your TV/VCR using one of the connections shownHooking Up the TV/VCR Rod AntennaHooking Up the TV/VCR cont’d Audio and video cables are not suppliedCrooked Pin Straight Pin Turning On the TV/VCR Press the Power button. The TV/VCR willYou cannot set up channels if you are using a Cable Box Select another channelPress the Menu button Language SelectionPress the Menu button Press the STATUS/EXIT but TonAutomatic Channel Setup Wait for the TV/VCR to set up channelsLine Input mode Press the CHannel o/p buttons or Adding/Deleting ChannelsSteps Repeat steps 3-4 to add or delete other channelsCable Box users must set the clock manually Setting the ClockManual Clock Setting Channels are set. Details are onSetting the Clock cont’d PM, press 09, 30Buttons for the year. For example, for July Press the PLAY/ button or the STOP/ but- 1,4 Ton to select PRIM. SETUP. Then, pressAutomatic PBS Channel Selection FWD/B buttonNOW Searching flashes on the TV/VCR screen Wait for the TV/VCR to find the timeManual PBS Channel Selection Use the Number buttons to select your PBS station Daylight-Savings Time Time Zone Clock is OFFFront Panel Details are on page six ANTenna Jack AC Power CordRear Panel To the TV/VCRRemote Control Buttons STOP/ Button Clear ButtonSTATUS/EXIT Button ALT. CH Alternate Channel ButtonPress the PLAY/ button or the STOP/ but Refer to the chart onWhen you finish, press the STATUS/EXIT but- ton Menus on page 25 will disapMore brilliant Adjusting the Picture Controls cont’dDecrease Increase Decreased brightnessIf you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFFReminder Playing Follow the steps below to play a tapeHrs Read and follow the steps below to record a TV programTo stop recording, press the STOP/ button Tape Speeds Recording options are on pagesTV/VCR will turn off at the end of the OTR One-Touch RecordingTape is in the TV/VCR. The record tab must be intact Ton on the TV/VCR to stopTV/VCR is now in Line Input mode Rerecording Tape DuplicationTimer Recording DailyDetails are on Follow the instructions in to set Recording’s stop time. AM or PM will be setAutomatically Timer Recording cont’d You cannot use the Speed button at this timeIf Program not Completed appears, start again at step Checking or Clearing Timer Recordings During the power failureDefeat Recording Follow the steps below to prevent accidental recordingTUS/EXIT button Play mode Repeat PlayTV programming will appear while the tape is rewinding B Repeat Play Insert a tape in the TV/VCR Press the Menu buttonInsert a tape in the TV/VCR Power Will become a flashing BSetting will be lost Counter will appear on the screenForward and Reverse Searching SP/LP/SLP Still modePlayback Options Super High Speed Searching LP/SLPUse the Number buttons to enter your access code SmartLockSmartlock menu will appear Example Specific Sub-ratings Ratings will remain blocked even after a power failureSmartLock cont’d BLOCKED... message appearsSame code in the Confirm Code space Use the Number buttons to enter your old access codeUse the Number buttons to enter your desired Active code againRating Explanations To select Blue BACKGROUND. Then, press Blue BackgroundPress the PLAY/o button or the STOP/p button FWD/B button repeatedly so that OFF or onSleep Timer Sleep timer during a recordingWake Up Timer Volume Bar Closed Caption ExampleMenu Screen Sample Picture Standard Closed Captions Sample Picture Half-screen textAutomatic Operation Features Glossary Helpful Hints Helpful Hints cont’d Specifications Renewed Index MC132DMG/MC192DMG 3/22/02 121 PM Supplied Accessories