Edimax Technology WP-S1000 user manual Make a NEW USB Flash Disk with Client Software PnS Token

Page 28

4.MAKE A NEW USB FLASH DISK WITH CLIENT SOFTWARE (PnS TOKEN)

We only provide 2 USB flash disks. If you need more USB flash disks, you can build it using your USB flash disk/pen drive.

If you lost the USB flash disk that comes with your projector server, you can rebuild one with your own USB flash disk/pen drive too.

You’ll need:

„An USB flash disk/pen drive with capacity larger than 5MB (formatted)

„Installed the presentation client software into the USB flash disk/pen drive

Insert the USB flash disk into your computer’s USB port and start the presentation client software. Select ‘Make PnS Token’ from the menu of client software, then follows the instructions to build a new USB flash disk:

1. Click ‘Next’ when setup wizard appears.

27

Image 28
Contents WP-S1000 Wireless Projector Server Index Product Introduction and Features Product IntroductionMain Features Safety Information Linux Open-Source CodePackage Contents Familiar With WP-S1000 Front ViewBack View Install Your Wireless Projector Server WPS Hardware InstallationDigit Random Login Code Current Configuration Page Make software USB Flash PnS Token by yourself Page Software Installation Using the USB Flash Page Page Page Page Page Software Installation From the WPS Page Page Page Page Presentation Mode Familiar with Presentation Client SoftwareVideo Playing Mode Menu Make a NEW USB Flash Disk with Client Software PnS Token Page Using WEB Administration Interface Open the Web Administration InterfaceDefault password of conference control menu is ‘admin’ Download Default password is ‘admin’ Conference ControlPage Admin Page System Status Network Setup Page Projection Setup Change Passwords Reset to Default Firmware Upgrade Reboot System Troubleshooting AppendixBy Yourself if YOU’RE not Sure What Antenna YOU Reset The Projector Server To Factory Default Setting HereSet Up The Wireless Projector Server WPS To The Internet Select Use the following IP Address. Configure