Edimax Technology WP-S1000 user manual Product Introduction and Features

Page 3

1. PRODUCT INTRODUCTION

1.1.Product Introduction and Features

Thank you for purchasing this wireless projector server - WP-S1000! This projector server is an user-friendly presentation video server, you can connect this server to video projector or any CRT / LCD monitor with 15-pin D-sub video connector and support XGA resolution (1024 x 768 pixels), and share the projector or CRT / LCD monitor with every computer equipped with wired or wireless network connection.

¾Wired and Wireless Network Connection

WP-S1000 projector server supports both wired and wireless network connection. High-performance 100Mbps wired Ethernet connection and 54Mbps wireless Ethernet connection provides smooth video and audio performance.

¾Audio Support

Video alone is good enough, but with audio, your presentation will become more outstanding.

WP-S1000 projector server also provides audio function. If your computer equips with audio interface, WP-S1000 is also capable to transmit the audio from your computer to external

speaker or amplifier via built-in audio interface.

¾No more hassle cables

WP-S1000 projector server only requires few connection cables - power, video, audio (optional), and network (optional). In most cases with computers equipped with wireless

network interface, you only need power and video connection for this projector server, and you can get it installed within 1 minute!

¾Easy to Setup

WP-S1000 projector server supports DHCP (Dynamic Host Configuration Protocol), which is

very common nowadays. You only have to connect the network cable to the projector server,

and WP-S1000 will setup required network parameters automatically!

2

Image 3
Contents WP-S1000 Wireless Projector Server Index Product Introduction Product Introduction and FeaturesMain Features Linux Open-Source Code Safety InformationPackage Contents Front View Familiar With WP-S1000Back View Hardware Installation Install Your Wireless Projector Server WPSDigit Random Login Code Current Configuration Page Make software USB Flash PnS Token by yourself Page Software Installation Using the USB Flash Page Page Page Page Page Software Installation From the WPS Page Page Page Page Familiar with Presentation Client Software Presentation ModeVideo Playing Mode Menu Make a NEW USB Flash Disk with Client Software PnS Token Page Open the Web Administration Interface Using WEB Administration InterfaceDefault password of conference control menu is ‘admin’ Download Conference Control Default password is ‘admin’Page Admin Page System Status Network Setup Page Projection Setup Change Passwords Reset to Default Firmware Upgrade Reboot System Appendix TroubleshootingBy Yourself if YOU’RE not Sure What Antenna YOU Here Reset The Projector Server To Factory Default SettingSelect Use the following IP Address. Configure Set Up The Wireless Projector Server WPS To The Internet