Edimax Technology WP-S1000 user manual

Page 23

9. Click ‘Next’ to start software installation procedure.

10.You’ll be prompted to enter Login Code, which is a 4-digit number displayed at the upper-left corner of the WPS. Enter Login Code and click ‘OK’ to connect to the WPS. You will be connected and the WPS will project your PC screen to the projector automatically.

NOTE: Login code

WILL CHANGE when:

a. Projector server rebooted. b. User logged out and when login again.

Image 23

Contents WP-S1000 Wireless Projector Server Index Product Introduction Product Introduction and FeaturesMain Features Linux Open-Source Code Safety InformationPackage Contents Front View Familiar With WP-S1000Back View Hardware Installation Install Your Wireless Projector Server WPSDigit Random Login Code Current Configuration Page Make software USB Flash PnS Token by yourself Page Software Installation Using the USB Flash Page Page Page Page Page Software Installation From the WPS Page Page Page Page Familiar with Presentation Client Software Presentation ModeVideo Playing Mode Menu Make a NEW USB Flash Disk with Client Software PnS Token Page Open the Web Administration Interface Using WEB Administration InterfaceDefault password of conference control menu is ‘admin’ Download Conference Control Default password is ‘admin’Page Admin Page System Status Network Setup Page Projection Setup Change Passwords Reset to Default Firmware Upgrade Reboot System Appendix TroubleshootingBy Yourself if YOU’RE not Sure What Antenna YOU Here Reset The Projector Server To Factory Default SettingSelect Use the following IP Address. Configure Set Up The Wireless Projector Server WPS To The Internet