Edimax Technology WP-S1000 Install Your Wireless Projector Server WPS, Hardware Installation

Page 9

2.INSTALL YOUR WIRELESS PROJECTOR SERVER (WPS)

Step 1) Hardware Installation.

Step 2) Make software USB Flash (PnS Token) by yourself.

Step 3) Software Installation. Choose one of the following:

i.Install the software using the USB Flash (Recommended)

ii.Install the software from the WPS (2nd Option)

Note: It’s recommended to install the software using the USB flash (Fast and Easier). However we only provide 2 USB flash disks, therefore we provide second option to install the software from the WPS. If you need more USB flash disks, you can build your own USB Flash disks, refer Chapter 4: Make a New USB Flash Disk with Client Software (PnS Token).

2.1 Hardware Installation

1.Use the mounting bracket and screws to mount the Wireless Project Server (WPS) on the wall. (Skip this step if this is not required.).

2.Connect the supplied antenna to the antenna connector located at the back of the WPS (labeled as ‘ANT’). Fasten and adjust the antenna to make it perpendicular to the ground.

8

Image 9

Contents WP-S1000 Wireless Projector Server Index Product Introduction Product Introduction and FeaturesMain Features Linux Open-Source Code Safety InformationPackage Contents Front View Familiar With WP-S1000Back View Hardware Installation Install Your Wireless Projector Server WPSDigit Random Login Code Current Configuration Page Make software USB Flash PnS Token by yourself Page Software Installation Using the USB Flash Page Page Page Page Page Software Installation From the WPS Page Page Page Page Familiar with Presentation Client Software Presentation ModeVideo Playing Mode Menu Make a NEW USB Flash Disk with Client Software PnS Token Page Open the Web Administration Interface Using WEB Administration InterfaceDefault password of conference control menu is ‘admin’ Download Conference Control Default password is ‘admin’Page Admin Page System Status Network Setup Page Projection Setup Change Passwords Reset to Default Firmware Upgrade Reboot System Appendix TroubleshootingBy Yourself if YOU’RE not Sure What Antenna YOU Here Reset The Projector Server To Factory Default SettingSelect Use the following IP Address. Configure Set Up The Wireless Projector Server WPS To The Internet