Avaya S8500 manual Type show control interface and press Enter

Chapter 6: IP interface configuration

4.To log into the IPSI, use SSH and the IP address 192.11.13.6.

For information on how to use SSH, see Accessing the command line interface of the server with SSH on page 87.

Note:

While connected to the IPSI, type help or ? to obtain online help. Most commands have two or three letter abbreviations.

5. Type ipsilogin and press Enter.

Note:

The craft login used on the IPSI has a different password from the craft login used on the media servers.

6.Log in as craft. Prompt = [IPADMIN]:

7.Type show control interface and press Enter and then type show port 1 and press Enter to see the current control interface settings.

8.To set the control interface, type set control interface ipaddr netmask and press Enter, where ipaddr is the customer-provided IP address and netmask is the customer provided subnet mask.

9.Type quit and press Enter to save the changes and exit the IPSI session.

10.Log back in to the IPSI using SSH.

11.Type show control interface and press Enter.

The system displays IP address, subnet mask, and default gateway information. Verify that the proper information was entered.

56 Installing and Configuring the Avaya S8500 Media Server February 2007