Chapter 2: SNMP Configuration
Default IP addresses for the UPS
The following table shows the default IP addresses for the UPS.
IP address for the UPS | 198.152.254.239 |
|
|
Subnet mask for the UPS | 255.255.255.0 |
|
|
Gateway address for the UPS | 198.152.254.201 |
|
|
IP address for the | Customer provided |
trap receiver (media server) |
|
|
|
For how to administer the SNMP module in the UPS, see Administering the SNMP module on page 29.
Prerequisites for configuring the SNMP module
Before you configure the SNMP module, you must complete the following prerequisites:
●Your Services laptop computer is plugged into the correct administration port on the SNMP module.
●The UPS is plugged into a nonswitched electrical outlet.
●The communication protocol on your computer has the following port settings so that you can use your terminal emulation program:
-9600 baud
-No parity
-8 data bits
-1 stop bit
-No flow control
Note:
Avaya Terminal Emulation and HyperTerminal are supported terminal emulation applications.
●If a Network Management System (NMS) is to monitor the UPS, you coordinated the assignment of community names with the network administrator. If an NMS is not used, you set the community names to unique string values.
28 Installing and Configuring the Avaya S8500 Media Server | February 2007 |