Chapter 4: Setting up your TV
Programming channels into the TV’s channel memory
When you press <or ,on the remote control or TV control panel, your TV will stop only on the channels you programmed into the TV’s channel memory.
Follow the steps below to program channels into the TV’s channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels in the channel memory.
Note:
•You must configure the antenna input source before programming channels (- page 18).
•If the Antenna 1 input signal type is set to Cable, the automatic channel programming process erases channels that were previously programmed into the TV’s memory.
•If the Antenna 1 input signal type is set to Antenna, the automatic channel programming process adds newly found channels to the existing set of programmed channels (and does NOT erase channels that were previously programmed into the TV’s memory.) To remove an Antenna source channel from the memory, you must manually delete it.
•To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.
•Programming channels when the antenna input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly.
To program channels automatically:
1 Make sure you have configured the antenna input source (- page 18).
2 Press Yand open the Setup menu.
3 Highlight Installation and press T.
Setup
Installation |
|
|
|
|
|
Sleep Timer |
|
|
|
|
|
PC Settings |
|
|
|
|
|
PC Audio |
| No |
|
|
|
HDMI Audio |
| Auto |
|
|
|
Slide Show Interval | 2 Sec | |
4 (A new set of Installation menu icons will appear on- screen, as shown below.) Open the Terrestrial menu, highlight Channel Program, and press T.
Terrestrial
Input Configuration
Channel Program 
Channel Add/Delete
Signal Meter
Navigate ENTER Select CH RTN Back EXIT Exit
5 Highlight ANT 1 and then press Tto start automatic channel programming.
ANT 1 Antenna
Scanning channels, please wait ...
52%
Abort
The TV will automatically cycle through all the antenna channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait” appears (as shown above).
6 To cancel channel programming, either press Oor highlight Abort in the
When channel programming is finished, press <or ,to view the programmed channels.
Manually adding and deleting channels in the channel memory
After automatically programming channels into the channel memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
1
2
3 (A new set of Installation menu icons will appear on- screen, as shown below) Open the Terrestrial menu, highlight Channel Add/Delete, and then press T.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate ENTER Select CH RTN Back EXIT Exit
Navigate ENTER Select CH RTN Back EXIT Exit
19