Sony MXD-D1 manual When LEVEL-SYNC is displayed during analog recording, Other cases

Page 27

Recording on MDs

When “LEVEL-SYNC” is displayed during analog recording

The track number is written in sync with the level of the input signal from the sound source. In other words, if the input signal from the sound source is continuously at or below a certain fixed level for several seconds, a track number is written the next time the input signal exceeds that level (see “Marking track numbers automatically” on page 28).

Track

 

 

1

2

3

4

 

number

 

A

B

C

D

 

Original

 

 

 

 

 

 

 

 

 

 

If the level does not drop below a certain fixed

 

level continuously for several seconds because

 

the interval between tracks is short, etc., no

Track

track number is

 

written. .

 

 

 

 

 

 

 

 

 

 

 

1

 

 

2

3

4

 

number

 

 

 

A

 

B

C

C

D

 

Recorded

 

 

MD

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If the level does drop below a certain fixed level continuously for several seconds, even if in the middle of a track, a track number is written.

Note

When you select MIC with REC SOURCE SELECTOR, the track number is not written automatically even if “LEVEL- SYNC”appears in the display.

Other cases

Only one track number is written at the start of a recording. The entire recording is counted as one track. You can mark track numbers during recording, either manually or automatically (see “Marking track numbers manually” on page 28).

Track

 

 

1

2

3

4

 

number

 

A

B

C

D

 

Original

 

 

 

 

 

 

.

 

 

 

Only one track number is written at the

Track

 

 

start of a recording.

 

 

 

1

2

3

4

 

 

number

 

 

A

B

C

D

 

 

Recorded

 

 

 

 

 

 

 

MD

 

 

 

 

 

 

When “TOC” flashes in the display

Do not move the unit or pull out the AC power cord. If you do, the recorded material may not be saved normally because the MD deck section is updating the Table Of Contents (TOC).

Do not disconnect the AC power cord immediately after recording

If you do, the recorded material may not be saved to the MD.

To protect an MD against accidental erasure

To make it impossible to record on an MD, slide the tab in the direction by the arrow, opening the slot. “Protected” appears in the display if you attempt to record on the MD. To allow recording, close the slot.

Rear of the disc

Record-protect tab

Slide the tab in the direction by the arrow

24EN

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Compact Disc MiniDisc Deck Page Page Page Precautions About This Manual WelcomeInserting batteries into the remote Preparing the connecting cordsUnpacking Hooking Up the SystemConnecting the AC power cord Connecting the unit to an amplifierHooking up the system Do the following When you play an 8-cm CDTo use headphones You can locate and play a track while the player is stoppedPlaying an MD Recording a CD on an MD Press When TOC flashes in the displayMusic calendar display Checking Remaining Time of aLocating a Specific Track on a Locating a Particular Point in a Track on a CD Playing Tracks on a CD Repeatedly Repeat PlayRepeating the current track Repeating a specific portion A-B Repeat Playing Tracks on a CD in Random Order Shuffle PlayChanging the track order Playing Tracks on a CD in the Desired Order Program PlayDifference between Normal Normal modeRhythm mode Looping Part of a CD Loop PlayRecording the current track on an MD Rec-It Useful Tips When Recording from CDsPausing after each track Auto Pause Inserting blank spaces while recording to tape Auto SpaceChecking remaining time and track title Checking Remaining Time of anTo pause playback at the beginning of a track Locating a Specific Track on anWhen the MD is played Player repeats Locating a Particular Point in a Track on an MDPlaying Tracks on an MD Repeatedly Repeat Play Playing tracks on an MD in Random Order Shuffle Play Playing Tracks on an MD in the Desired Order Program Play To restart playback Useful Tips When Recording from MDs to TapeTrack Marking Digital Recording and Analog RecordingOther cases When LEVEL-SYNC is displayed during analog recordingTo play from the first track of the MD after recording Useful Tips for RecordingChecking the remaining recordable time on the MD Playing back tracks just recordedDigital recording Analog recordingRecording the Mixed Sounds Microphone Mixing Adjusting the Recording LevelMarking Track Numbers while Recording Track Marking To stop Time Machine Recording Seconds of Prestored Audio Data Time Machine RecordingTo cancel Automatic Track Marking Starting Recording withErasing Recordings Erase Function Erasing a single trackIf Protected appears in the display To cancel the Erase function Erasing a portion of a trackErasing all tracks on an MD You can divide a track while recording To cancel the Divide functionDividing Recorded Tracks Divide Function You can undo a track divisionTo cancel the Combine function Combining Recorded Tracks Combine FunctionYou can undo a track combination Moving Recorded Tracks Move Function To cancel the Move functionLabeling Recordings Title Function Labeling tracks and MDs with the remote Changing an existing titleErasing all titles on a disc Name Erase To cancel the Undo function Undoing the Last Edit Undo FunctionEditing done Message Some tracks cannot be combined with others MD Display MessagesSystem Limitations of MD Message MeaningTroubleshooting CD player sectionMD deck section There is no sound GeneralRecording is not possible Sound has a lot of staticSpecifications Rule Guide to the Serial Copy Management System43EN Index J, KW, X, Y, Z Buttons Names of controlsPrécautions Enregistrement synchronisé d’un CD Présentation du mode d’emploiBienvenue Lecture d’un CD Lecture d’un MDAperçu Mise en place des piles dans la télécommandeDéballage Raccordement de la platineRemarque Raccordement de la platineRaccordement au secteur Raccordement de la platine à un amplificateurPour Vous devez Lecture d’un CDLecture d’un MD Enregistrement d’un CD sur un MD Pour Appuyez sur Quand TOC clignote sur l’afficheurAffichage du répertoire Vérification du temps restant sur un CDPour revenir rapidement au début de la plage précédente Localisation d’une plage donnée sur un CDPour localiser Vous devez Pour faire une pause au début d’une plageLocalisation d’un point donné d’une plage sur un CD Lecture répétée des plages d’un CD lecture répétéeRépétition de la plage en cours Pour annuler la lecture aléatoire Répétition d’un passage donné d’une plage répétition A-B ZPour annuler la répétition A-B Pose de nouveaux points de départ et de finChangement de l’ordre des plages Différence entre Normal et Rhythm En mode NormalEn mode Rhythm Lecture en boucle d’une partie d’un CD lecture en boucle ZPour poursuivre la lecture Conseils utiles pour l’enregistrement d’un CD ZEnregistrement de la plage en cours sur un MD Rec-it Pour annuler l’espacement automatiqueVérification du temps restant et du titre d’une plage Vérification du temps restant sur un MDScan Localisation d’une plage donnée sur un MDQuand vous écoutez un MD La platine répète En mode de Localisation d’un point donné d’une plage d’un MDLecture répétée des plages d’un MD lecture répétée 20F 21F Pause après chaque plage pause automatique Remarques sur ’enregistrementEgauqrMa Numéro De plage Original Autres casLecture à partir du début du MD après un enregistrement Conseils utiles pourEuqigolana tnmertsigernE Euqimérun mentertsigernEREC Level Réglage du niveau d’enregistrementAprès avoir terminé le mixage Si vous avez Tournez MIX Balance ChoisiEgalp Si vous ne choisissez qu’une seule sourceSur AMS à l’étape Pour annuler le marquage automatiqueSi Protected apparaît sur l’afficheur Remarques sur le montageEffacement d’un enregistrement fonction d’effacement Effacement d’une seule plageEffacement de toutes les plages d’un MD Effacement d’un passage d’une plagePour annuler la fonction d’effacement Vous pouvez diviser une plage pendant l’enregistrement Division d’une plage enregistrée fonction de divisionPour annuler la fonction de division Vous pouvez supprimer une division de plageVous pouvez supprimer une combinaison de plages Pour annuler la fonction de combinaisonPour annuler la fonction de déplacement Déplacement d’une plage enregistrée Fonction de déplacementPour entrer un espace Titrage d’un enregistrement fonction de titragePour titrer Assurez-vous que la platine est Pour effacer un caractèrePour sélectionner Appuyez plusieurs fois sur Titrage des plages et MD à l’aide de la télécommande ZChangement d’un titre Z Pour changerPour annuler la fonction de annulation Certaines plages ne peuvent pas être recombinées Messages MD affichésLimites du système MD Messages SignificationGuide de dépannage Section lecteur CDSection platine MD Le son est très parasité La télécommande ne fonctionne pasGénéralités ’enregistrement n’est pas possibleSpécifications Guide du système de protection contre la copie abusive Scms Deuxième règlePremière règle Troisième règle X, Y, Z G, H, I, J, KTouches Nomenclature

MXD-D1 specifications

The Sony MXD-D1, a versatile and robust component in the world of audio recording and playback, stands out with its unique blend of features tailored for audiophiles and casual listeners alike. This digital audio recorder and CD deck, released in the early 2000s, combines the best of both analog and digital technologies, making it a valuable asset in any sound setup.

One of the MXD-D1's main features is its dual functionality as both a CD player and a digital audio recorder. This duality allows users to seamlessly transition between enjoying their favorite music and creating digital recordings. The device supports both CD-R and CD-RW formats, enabling the recording of high-quality audio without the need for cumbersome cassette tapes or bulkier recording equipment. The intuitive interface makes it easy to navigate through tracks and recording options, ensuring an enjoyable experience for users at any level of expertise.

Another notable characteristic of the MXD-D1 is its advanced digital signal processing (DSP) capabilities. This technology enhances sound quality, providing cleaner audio with minimal distortion. Coupled with a high-resolution 24-bit ADC (analog-to-digital converter) and a 16-bit codec, the MXD-D1 captures sound with remarkable accuracy, preserving the nuances of the original recording.

The device also features a built-in digital timer and various modes for programming recordings, allowing users to create playlists or capture specific sections of audio. It has multiple input and output options, including optical and coaxial digital connections, ensuring compatibility with a variety of audio systems. The front panel includes a large LCD display that shows information about the track, playtime, and recording settings, facilitating easy navigation and monitoring.

In terms of build quality, the Sony MXD-D1 is designed with durability in mind. Its sleek and unobtrusive design fits well into any audio equipment setup while maintaining a professional appearance. Moreover, the low-noise operation ensures that it does not interfere with the integrity of recordings or playback.

In conclusion, the Sony MXD-D1 represents a significant advancement in digital audio technology. With its dual CD deck and recorder functionality, high-quality DSP capabilities, and versatile connections, it caters to the needs of both enthusiasts and professionals. Its ability to deliver precise sound and ease of use makes it a noteworthy addition to any audio collection.
Top Page Image Contents