Sony MXD-D1 manual Troubleshooting, CD player section, MD deck section

Page 42

Track numbers may not be recorded correctly

When recording a CD digitally, small extra tracks may be created due to the contents of the CD recording.

In addition, when track marking is performed automatically with “LevelSync ON”, the track numbers may not be recorded correctly, depending on the material being recorded.

“TOC Reading” appears for a long time

If the inserted recordable MD is brand new, “TOC Reading” appears in the display longer than for MDs that have been used.

Tracks edited many times may exhibit sound dropout during playback.

Limitations when recording over an existing track

The correct remaining recording time may not be displayed.

You may find it impossible to record over a track if that track has been recorded over several times already. If this happens, erase the track using the Erase function.

The remaining recording time may be shortened out of proportion to the total recorded time.

Recording over a track to eliminate noise is not recommended since this may shorten the duration of the track.

You may find it impossible to label a track while recording over it.

The correct recorded/playing time may not be displayed during playback of monaural-format MDs.

Additional Information

Troubleshooting

If you experience any of the following difficulties while using the unit, use this troubleshooting guide to help you remedy the problem. First check that the power cord is connected firmly and the unit is on.

Should any problem persist, consult your nearest Sony dealer.

CD player section

The player does not start playing

/A CD is not in the disc tray. Insert a CD.

/The CD is inserted label side down. Place the CD properly.

/The CD is dirty. Clean the CD.

/Moisture condensation has formed inside the player. Take the CD out and leave the system turned on for about an hour until the moisture evaporates.

MD deck section

The player does not operate or operates poorly.

/The MD may be damaged (“Disc Error” appears). Take the MD out and insert it again. If “Disc Error” remains, replace the MD.

The player does not start playback.

/Moisture condensation has formed inside the player. Take the MD out and leave the system turned on for several hours until the moisture evaporates.

/The MD is inserted in the wrong direction. Slide the MD into the disc compartment with the label side up and the arrow pointing towards the opening until the player grips it.

/Nothing is recorded on the MD (The music calendar does not appear).

Replace the MD with one that has been recorded.

(Continued)

39EN

Image 42 Contents
Compact Disc MiniDisc Deck Page Page Page Precautions Welcome About This ManualHooking Up the System Preparing the connecting cordsUnpacking Inserting batteries into the remoteConnecting the AC power cord Connecting the unit to an amplifierHooking up the system You can locate and play a track while the player is stopped When you play an 8-cm CDTo use headphones Do the followingPlaying an MD Recording a CD on an MD When TOC flashes in the display PressChecking Remaining Time of a Music calendar displayLocating a Specific Track on a Locating a Particular Point in a Track on a CD Playing Tracks on a CD Repeatedly Repeat PlayRepeating the current track Playing Tracks on a CD in Random Order Shuffle Play Repeating a specific portion A-B RepeatPlaying Tracks on a CD in the Desired Order Program Play Changing the track orderLooping Part of a CD Loop Play Normal modeRhythm mode Difference between NormalInserting blank spaces while recording to tape Auto Space Useful Tips When Recording from CDsPausing after each track Auto Pause Recording the current track on an MD Rec-ItChecking Remaining Time of an Checking remaining time and track titleLocating a Specific Track on an To pause playback at the beginning of a trackWhen the MD is played Player repeats Locating a Particular Point in a Track on an MDPlaying Tracks on an MD Repeatedly Repeat Play Playing tracks on an MD in Random Order Shuffle Play Playing Tracks on an MD in the Desired Order Program Play Useful Tips When Recording from MDs to Tape To restart playbackDigital Recording and Analog Recording Track MarkingWhen LEVEL-SYNC is displayed during analog recording Other casesPlaying back tracks just recorded Useful Tips for RecordingChecking the remaining recordable time on the MD To play from the first track of the MD after recordingAnalog recording Digital recordingAdjusting the Recording Level Recording the Mixed Sounds Microphone MixingMarking Track Numbers while Recording Track Marking Starting Recording with Seconds of Prestored Audio Data Time Machine RecordingTo cancel Automatic Track Marking To stop Time Machine RecordingErasing Recordings Erase Function Erasing a single trackIf Protected appears in the display To cancel the Erase function Erasing a portion of a trackErasing all tracks on an MD You can undo a track division To cancel the Divide functionDividing Recorded Tracks Divide Function You can divide a track while recordingTo cancel the Combine function Combining Recorded Tracks Combine FunctionYou can undo a track combination To cancel the Move function Moving Recorded Tracks Move Function Labeling Recordings Title Function Labeling tracks and MDs with the remote Changing an existing titleErasing all titles on a disc Name Erase To cancel the Undo function Undoing the Last Edit Undo FunctionEditing done Message Message Meaning MD Display MessagesSystem Limitations of MD Some tracks cannot be combined with othersTroubleshooting CD player sectionMD deck section Sound has a lot of static GeneralRecording is not possible There is no soundSpecifications Guide to the Serial Copy Management System Rule43EN Index J, KW, X, Y, Z Names of controls ButtonsPrécautions Lecture d’un CD Lecture d’un MD Présentation du mode d’emploiBienvenue Enregistrement synchronisé d’un CDRaccordement de la platine Mise en place des piles dans la télécommandeDéballage AperçuRaccordement de la platine à un amplificateur Raccordement de la platineRaccordement au secteur RemarqueLecture d’un CD Pour Vous devezLecture d’un MD Enregistrement d’un CD sur un MD Quand TOC clignote sur l’afficheur Pour Appuyez surVérification du temps restant sur un CD Affichage du répertoirePour faire une pause au début d’une plage Localisation d’une plage donnée sur un CDPour localiser Vous devez Pour revenir rapidement au début de la plage précédenteLocalisation d’un point donné d’une plage sur un CD Lecture répétée des plages d’un CD lecture répétéeRépétition de la plage en cours Pose de nouveaux points de départ et de fin Répétition d’un passage donné d’une plage répétition A-B ZPour annuler la répétition A-B Pour annuler la lecture aléatoireChangement de l’ordre des plages Lecture en boucle d’une partie d’un CD lecture en boucle Z En mode NormalEn mode Rhythm Différence entre Normal et RhythmPour annuler l’espacement automatique Conseils utiles pour l’enregistrement d’un CD ZEnregistrement de la plage en cours sur un MD Rec-it Pour poursuivre la lectureVérification du temps restant sur un MD Vérification du temps restant et du titre d’une plageLocalisation d’une plage donnée sur un MD ScanQuand vous écoutez un MD La platine répète En mode de Localisation d’un point donné d’une plage d’un MDLecture répétée des plages d’un MD lecture répétée 20F 21F Pause après chaque plage pause automatique Remarques sur ’enregistrementEgauqrMa Autres cas Numéro De plage OriginalConseils utiles pour Lecture à partir du début du MD après un enregistrementEuqimérun mentertsigernE Euqigolana tnmertsigernERéglage du niveau d’enregistrement REC LevelSi vous ne choisissez qu’une seule source Si vous avez Tournez MIX Balance ChoisiEgalp Après avoir terminé le mixagePour annuler le marquage automatique Sur AMS à l’étapeEffacement d’une seule plage Remarques sur le montageEffacement d’un enregistrement fonction d’effacement Si Protected apparaît sur l’afficheurEffacement de toutes les plages d’un MD Effacement d’un passage d’une plagePour annuler la fonction d’effacement Vous pouvez supprimer une division de plage Division d’une plage enregistrée fonction de divisionPour annuler la fonction de division Vous pouvez diviser une plage pendant l’enregistrementPour annuler la fonction de combinaison Vous pouvez supprimer une combinaison de plagesDéplacement d’une plage enregistrée Fonction de déplacement Pour annuler la fonction de déplacementPour effacer un caractère Titrage d’un enregistrement fonction de titragePour titrer Assurez-vous que la platine est Pour entrer un espacePour changer Titrage des plages et MD à l’aide de la télécommande ZChangement d’un titre Z Pour sélectionner Appuyez plusieurs fois surPour annuler la fonction de annulation Messages Signification Messages MD affichésLimites du système MD Certaines plages ne peuvent pas être recombinéesGuide de dépannage Section lecteur CDSection platine MD ’enregistrement n’est pas possible La télécommande ne fonctionne pasGénéralités Le son est très parasitéSpécifications Guide du système de protection contre la copie abusive Scms Deuxième règlePremière règle Troisième règle G, H, I, J, K X, Y, ZNomenclature Touches