Sony MXD-D1 manual Precautions

Page 5

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.

The laser component in this product is capable of emitting radiation exceeding the limit for Class 1.

CAUTION

TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

IN NO EVENT SHALL SELLER BE LIABLE FOR ANY DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.

Precautions

On safety

Should any solid object or liquid fall into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further.

On power sources

•Before operating the unit, check that the operating voltage of the unit is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the unit.

•If you are not going to use the unit for a long time, be sure to disconnect the unit from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord.

On condensation in the unit

If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the unit. Should this occur, the unit may not operate properly. In this case, remove the CD or MD and leave the unit turned on for about an hour until the moisture evaporates.

On handling CDs

•To keep the CD clean, handle the CD by its edge. Do not touch the surface.

•Do not stick paper or tape onto the CD.

•Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car.

On the MiniDisc cartridge

•Do not open the shutter to expose the MD.

•Do not place the cartridge where it will be subject to extremes of sunlight, temperature, moisture or dust.

On cleaning

Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.

If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.

2EN

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Compact Disc MiniDisc Deck Page Page Page Precautions About This Manual WelcomeUnpacking Preparing the connecting cordsHooking Up the System Inserting batteries into the remoteHooking up the system Connecting the AC power cordConnecting the unit to an amplifier To use headphones When you play an 8-cm CDYou can locate and play a track while the player is stopped Do the followingPlaying an MD Recording a CD on an MD Press When TOC flashes in the displayMusic calendar display Checking Remaining Time of aLocating a Specific Track on a Repeating the current track Locating a Particular Point in a Track on a CDPlaying Tracks on a CD Repeatedly Repeat Play Repeating a specific portion A-B Repeat Playing Tracks on a CD in Random Order Shuffle PlayChanging the track order Playing Tracks on a CD in the Desired Order Program PlayRhythm mode Normal modeLooping Part of a CD Loop Play Difference between NormalPausing after each track Auto Pause Useful Tips When Recording from CDsInserting blank spaces while recording to tape Auto Space Recording the current track on an MD Rec-ItChecking remaining time and track title Checking Remaining Time of anTo pause playback at the beginning of a track Locating a Specific Track on anPlaying Tracks on an MD Repeatedly Repeat Play When the MD is played Player repeatsLocating a Particular Point in a Track on an MD Playing tracks on an MD in Random Order Shuffle Play Playing Tracks on an MD in the Desired Order Program Play To restart playback Useful Tips When Recording from MDs to TapeTrack Marking Digital Recording and Analog RecordingOther cases When LEVEL-SYNC is displayed during analog recordingChecking the remaining recordable time on the MD Useful Tips for RecordingPlaying back tracks just recorded To play from the first track of the MD after recordingDigital recording Analog recordingRecording the Mixed Sounds Microphone Mixing Adjusting the Recording LevelMarking Track Numbers while Recording Track Marking To cancel Automatic Track Marking Seconds of Prestored Audio Data Time Machine RecordingStarting Recording with To stop Time Machine RecordingIf Protected appears in the display Erasing Recordings Erase FunctionErasing a single track Erasing all tracks on an MD To cancel the Erase functionErasing a portion of a track Dividing Recorded Tracks Divide Function To cancel the Divide functionYou can undo a track division You can divide a track while recordingYou can undo a track combination To cancel the Combine functionCombining Recorded Tracks Combine Function Moving Recorded Tracks Move Function To cancel the Move functionLabeling Recordings Title Function Erasing all titles on a disc Name Erase Labeling tracks and MDs with the remoteChanging an existing title Editing done Message To cancel the Undo functionUndoing the Last Edit Undo Function System Limitations of MD MD Display MessagesMessage Meaning Some tracks cannot be combined with othersMD deck section TroubleshootingCD player section Recording is not possible GeneralSound has a lot of static There is no soundSpecifications Rule Guide to the Serial Copy Management System43EN W, X, Y, Z IndexJ, K Buttons Names of controlsPrécautions Bienvenue Présentation du mode d’emploiLecture d’un CD Lecture d’un MD Enregistrement synchronisé d’un CDDéballage Mise en place des piles dans la télécommandeRaccordement de la platine AperçuRaccordement au secteur Raccordement de la platineRaccordement de la platine à un amplificateur RemarquePour Vous devez Lecture d’un CDLecture d’un MD Enregistrement d’un CD sur un MD Pour Appuyez sur Quand TOC clignote sur l’afficheurAffichage du répertoire Vérification du temps restant sur un CDPour localiser Vous devez Localisation d’une plage donnée sur un CDPour faire une pause au début d’une plage Pour revenir rapidement au début de la plage précédenteRépétition de la plage en cours Localisation d’un point donné d’une plage sur un CDLecture répétée des plages d’un CD lecture répétée Pour annuler la répétition A-B Répétition d’un passage donné d’une plage répétition A-B ZPose de nouveaux points de départ et de fin Pour annuler la lecture aléatoireChangement de l’ordre des plages En mode Rhythm En mode NormalLecture en boucle d’une partie d’un CD lecture en boucle Z Différence entre Normal et RhythmEnregistrement de la plage en cours sur un MD Rec-it Conseils utiles pour l’enregistrement d’un CD ZPour annuler l’espacement automatique Pour poursuivre la lectureVérification du temps restant et du titre d’une plage Vérification du temps restant sur un MDScan Localisation d’une plage donnée sur un MDLecture répétée des plages d’un MD lecture répétée Quand vous écoutez un MD La platine répète En mode deLocalisation d’un point donné d’une plage d’un MD 20F 21F Pause après chaque plage pause automatique EgauqrMa Remarques sur’enregistrement Numéro De plage Original Autres casLecture à partir du début du MD après un enregistrement Conseils utiles pourEuqigolana tnmertsigernE Euqimérun mentertsigernEREC Level Réglage du niveau d’enregistrementEgalp Si vous avez Tournez MIX Balance ChoisiSi vous ne choisissez qu’une seule source Après avoir terminé le mixageSur AMS à l’étape Pour annuler le marquage automatiqueEffacement d’un enregistrement fonction d’effacement Remarques sur le montageEffacement d’une seule plage Si Protected apparaît sur l’afficheurPour annuler la fonction d’effacement Effacement de toutes les plages d’un MDEffacement d’un passage d’une plage Pour annuler la fonction de division Division d’une plage enregistrée fonction de divisionVous pouvez supprimer une division de plage Vous pouvez diviser une plage pendant l’enregistrementVous pouvez supprimer une combinaison de plages Pour annuler la fonction de combinaisonPour annuler la fonction de déplacement Déplacement d’une plage enregistrée Fonction de déplacementPour titrer Assurez-vous que la platine est Titrage d’un enregistrement fonction de titragePour effacer un caractère Pour entrer un espaceChangement d’un titre Z Titrage des plages et MD à l’aide de la télécommande ZPour changer Pour sélectionner Appuyez plusieurs fois surPour annuler la fonction de annulation Limites du système MD Messages MD affichésMessages Signification Certaines plages ne peuvent pas être recombinéesSection platine MD Guide de dépannageSection lecteur CD Généralités La télécommande ne fonctionne pas’enregistrement n’est pas possible Le son est très parasitéSpécifications Première règle Guide du système de protection contre la copie abusive ScmsDeuxième règle Troisième règle X, Y, Z G, H, I, J, KTouches Nomenclature

MXD-D1 specifications

The Sony MXD-D1, a versatile and robust component in the world of audio recording and playback, stands out with its unique blend of features tailored for audiophiles and casual listeners alike. This digital audio recorder and CD deck, released in the early 2000s, combines the best of both analog and digital technologies, making it a valuable asset in any sound setup.

One of the MXD-D1's main features is its dual functionality as both a CD player and a digital audio recorder. This duality allows users to seamlessly transition between enjoying their favorite music and creating digital recordings. The device supports both CD-R and CD-RW formats, enabling the recording of high-quality audio without the need for cumbersome cassette tapes or bulkier recording equipment. The intuitive interface makes it easy to navigate through tracks and recording options, ensuring an enjoyable experience for users at any level of expertise.

Another notable characteristic of the MXD-D1 is its advanced digital signal processing (DSP) capabilities. This technology enhances sound quality, providing cleaner audio with minimal distortion. Coupled with a high-resolution 24-bit ADC (analog-to-digital converter) and a 16-bit codec, the MXD-D1 captures sound with remarkable accuracy, preserving the nuances of the original recording.

The device also features a built-in digital timer and various modes for programming recordings, allowing users to create playlists or capture specific sections of audio. It has multiple input and output options, including optical and coaxial digital connections, ensuring compatibility with a variety of audio systems. The front panel includes a large LCD display that shows information about the track, playtime, and recording settings, facilitating easy navigation and monitoring.

In terms of build quality, the Sony MXD-D1 is designed with durability in mind. Its sleek and unobtrusive design fits well into any audio equipment setup while maintaining a professional appearance. Moreover, the low-noise operation ensures that it does not interfere with the integrity of recordings or playback.

In conclusion, the Sony MXD-D1 represents a significant advancement in digital audio technology. With its dual CD deck and recorder functionality, high-quality DSP capabilities, and versatile connections, it caters to the needs of both enthusiasts and professionals. Its ability to deliver precise sound and ease of use makes it a noteworthy addition to any audio collection.
Top Page Image Contents