Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
í
î
To remove the display mask, follow the steps below.
1.Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2.Remove the battery pack.
3.Remove two rubber seals at the bottom corners of the display assembly.
4.Remove two M2.5x6 screws that were covered by the rubber seals.
NOTE: Support the display with your hand when you remove the screws.
5.Using the fingers of both hands, carefully release the 18 latches along the edges of the display mask. Begin at the top (six latches), continue along the sides (four latches on each side) and the bottom (four latches).
To remove the FL inverter board, follow the steps below.
1.Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2.Remove the battery pack and the display mask.
3.Lay the display panel on its back.
4.Remove two M2.5x6 screws securing the FL inverter board.
5.Lift up the FL inverter board and disconnect the FL cable.
6.Rotate out the top end of the FL inverter board. Disconnect the FL inverter cable and lift out the FL inverter board.
Toshiba TRR | Page 19 | 4/00, Tecra |