Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
î
To install the HDD pack, follow the steps below.
1.Align the HDD pack with the marker on the computer and seat the HDD so that tabs on the HDD fit into notches on the computer.
2.Make sure the cover is pushed fully to the right and push the HDD back to ensure a firm connection.
3.Slide the cover to the left to lock the HDD into the slot.
4.Install the battery pack.
To remove the memory module(s), make sure the computer is in boot mode and follow the steps below.
CAUTION: Do not try to remove a memory module(s) with the computer turned on. You can damage the computer and the memory module(s).
1.Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2.Remove the battery pack and HDD pack.
3.Lift up the mylar cover.
4.Use a slender object (plastic card) to press the latches on either side of the memory module(s) to the outside and the memory module will pop up.
5.Grasp the memory module(s) by the sides and pull it out.
CAUTION: Do not touch the connectors on the memory module(s) or on the computer. Debris on the connectors may cause memory access problems.
The modem board is located under the palmrest. To open the palmrest, follow the steps below.
1.Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2.Remove the battery pack, optional PC card, and HDD pack.
3.With the computer still upside down, remove two M2x8 silver screws, two M2x22 silver screws and two M2x14 silver screws.
4.Turn the computer right side up and open the display panel and PC card cover.
5.Grasp the sides of the palmrest and pull it forward until tabs on either side clear the holes on the top cover. Three latches are located under the palmrest as shown below.
6.Carefully lift the palmrest.
î
Images / text continued on the next page
Toshiba TRR | Page 12 | 4/00, Tecra |