Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
You can use the SelectBay cover when you do not need to use a SelectBay module.
1. To install the cover, first remove the SelectBay module then hold the cover by the two finger grips and push it into place until you hear the latches click.
2. To remove the cover, grasp the two finger grips and pull the cover out.
To disassemble the
1. Remove six M2x3 silver screws and two M2.5x6 silver screws securing the frame to the
2. Remove the connector cover.
3. Remove the metal frame, connector board, and disconnect the flexible cable.
î
| To disassemble the FDD, follow the steps below. | |
| 1. | Remove six M2x6 silver screws. |
| 2. | Turn the FDD over and release two |
|
| latches securing the upper plastic |
|
| frame and lower plastic frame. Turn it |
|
| back over and lift off the cover. |
| 3. | Lift off the upper shield cover, unseat |
|
| the flexible cable connector from the |
|
| lower plastic frame, then lift out the |
|
| FDD. |
| 4. | Pull the flexible cable out of the FDD |
|
| connector. |
ê | 5. | Remove four M2x3 silver screws and |
| remove the FDD from the bracket. | |
|
| |
è
Toshiba TRR | Page 9 | 4/00, Tecra |