Toshiba manual Tecra 780CDM / 780DVD Disassembly Overview, Be careful when removing the module

Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.

Remove the battery pack.

Open or remove the PC card slot cover. Press in slightly on the eject button for the upper and/or lower card and the button will pop out fully.

Now, press the button firmly to pop the PC card out partially.

Grasp the PC card and remove it. Close or replace the PC card slot cover.

Tecra 780CDM / 780DVD Disassembly Overview, (cont.)

To remove the optional PC card, make sure the computer is in boot mode, then follow the steps below.

1.

2.

3.

4.

5.

6.

7.

To install the PC card, follow the steps below.

1. Open or remove the PC card slot cover.

2. Insert the PC card and press gently to ensure a firm connection.

3. Close the slot cover or replace the cover with an appropriate one.

4. Install the battery pack.

To remove the SelectBay module, follow the steps below.

1. Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.

2. Remove the battery pack.

3. Turn the computer upside down and slide the SelectBay lock to the unlock position, shown by a red box.

4. Pull out the release lever.

5. Push the release lever in firmly to pop the SelectBay module partially out of the bay.

6. Grasp the module and pull it out.

CAUTION: The SelectBay modules can become hot with use.

Be careful when removing the module.

Install the SelectBay modules as described below.

1. Insert the module in the computer and press until it locks into place.

2. Fold the release lever into the closed position.

3. Slide the SelectBay lock to the locked position. The red box should not be visible.

4. Install the battery pack.

Toshiba TRR Page 8 4/00, Tecra