5. Hardware Installation
Before installing the PCI card, please make sure the computer is switched off and the power cable is disconnected from the mains supply. Inserting or removing a PCI card while the computer is in operation can cause irreparable damage to both motherboard and card!
1.Disconnect the power cord and all other cables from the computer.
2.Remove the computer's housing. Further information on how to do this can be obtained from your computer's instruction manual.
3.Important: Before removing the HDSP MADI from its protective bag, discharge any static in your body by touching the metal chassis of the PC.
4.Prior to installation: Connect the HDSP MADI card to the Expansion Board using the sup- plied flat ribbon cable.
5.Insert the HDSP MADI firmly into a free PCI slot, press and fasten the screw.
6.Insert the Expansion Board and fasten the screw.
7.Replace the computer's housing.
8.Reconnect all cables including the power cord.
6. Hardware - Connectors
6.1 External Connectors
The bracket of the main- board has two MADI inter- faces, optical and coaxial input and output each, a MADI error LED and the analog stereo output.
Identical signals are avail- able at both the optical and the coaxial output. An
obvious use for this would be to simply connect two devices, i.e. using the HDSP MADI as a splitter (distribution 1 to 2).
The Expansion Board's bracket has the word clock input and output. Next to the input BNC socket, a green LED dis- plays the word clock in- put's LOCK state. Be- tween the BNC sockets,
75Ohm word clock termi- nation can be activated and verified by a yellow LED.
The included breakout cable is connected to the
Note: If neither word clock I/O nor MIDI I/O are required, it is not necessary to install the Expan- sion Board at all.
User's Guide HDSP MADI © RME | 7 |