Onkyo DV-SP800 instruction manual Erasing the programmed command from one button

Erasing the programmed command from one button

		N		A
		SE	D/ LE	RN
PROGRAMMED			& LE	A
				RNING CAPABI				LITY
PRE
		ON	S
			TANDBY
							T
							V.V
									CR
	IINPUT		S L
			E ECTTOORR
		MO DE
DV	RCVR			VCR			TV
D
	ANGLE		SUBTTL
IO							LA
D							ST		M
AU
		ENU		M	EN
	PM					U
	TO
CH		ENTER					VOL
	R				UP
	ET	URN					VIDEO OFF
				SET
	DISPLAY				DIMMER		MUTING
AUDIO SEL
TV / VCR

SEND/LEARN

VCR

TV

You can only erase memorized commands and not preset ones.

1	Press and hold down the desired
	MODE button for the command,
	press the SEARCH button, and then
	release both buttons.
	When you release the buttons, the SEND/
	LEARN indicator lights.
2	Press and release the button for the
	command you wish to erase.
	When you press the button, the SEND/
	LEARN indicator turns off. When you
	release the button, the indicator lights
	again.
3	Press and release the same button
	again.

The SEND/LEARN indicator flashes twice.

The memorized command is erased.

Note

If no button is pressed for more than 30 seconds during the programming, the SEND/LEARN indicator flashes three times quickly, and the remote controller exits the programming mode. Resume from Step 1.

STEP/SLOW	PAUSE	STEP/SLOW
	SPEED
	SURROUND
REPEAT RANDOM PROGRAM CLEAR
A-B	PICTURE COND M	FUNCTION M
1	2	3
4	5	6
7	8	9
-- / ---		ENTER	SEARCH
+10	0	SEARCH

REMOTE CONTROLLER

RC-498DV

Erasing all the commands programmed under a MODE button

1	Press and hold down the desired
	MODE button, press the SEARCH
	button twice, and then release both
	buttons.
	When you release the buttons, the SEND/
	LEARN indicator flashes twice slowly and
	then lights again.
2	Press and release the same MODE
	button again.

When you release the button, the SEND/ LEARN indicator flashes twice slowly. This erases all the commands memorized to the MODE button.

Notes

•If no button is pressed for more than 30 seconds, the SEND/ LEARN indicator flashes three times quickly and the remote controller exits the programming mode. Resume Step 1.

•If you perform an invalid operation during programming, the SEND/LEARN indicator flashes three times quickly and the remote controller exits the programming mode. Resume from Step 1.

•If many commands have been programmed to the MODE button, then the SEND/LEARN indicator may remain lit for some time during Step 2. This is not a malfunction.

67