Onkyo DV-SP800 Before You Start, Setting the Voltage Selector Worldwide models only

Before You Start

Setting the Voltage Selector (Worldwide models only)

Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit.

Determine the proper voltage for your area: 220-230 V or 120 V. If the preset voltage is not correct for your area, insert a screwdriver into the groove in the switch. Slide the switch all the way to the upper (120 V) or to the lower (220-230 V), whichever is appropriate.

	COMPONENT 1		S VIDEO	VIDEO
Y	C /P	C /P

VIDEO

OUTPUT

VOLTAGE AC INLET

			SELECTOR
CH 1	CH 2 FRONT SURR 1 CENTER SURR 2		120V
L	L	SACD & DVD AUDIO/VIDEO PLAYER
ANALOG	SURR	MODEL NO. DV-SP800	220-230V
OUTPUT	1 1+2	DIGITAL
R	R	OUTPUT
	OPTICAL	COAXIAL

VOLTAGE

SELECTOR

120V

220-230V

Inserting the Batteries

1Open the battery compartment cover.

Notes

•Do not mix new batteries with old batteries or different kinds of batteries.

•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.

•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, replace both batteries at the same time.

•The life of the batteries supplied is about six months but this will vary depending on usage.

Using the Remote Controller

Point the remote controller toward the remote control sensor.

Remote control sensor

30˚

30˚

2Insert the two R6 (size AA) batteries.

Be sure to match the + and – ends of the batteries with the diagram inside the battery compartment.

Notes

•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.

•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.

•Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries.

•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.

•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

3Close the battery compartment cover.

9