Onkyo Message no Play appears on, Display? Buttons on the DV, CP701 and remote con

Symptom	Possible cause	Remedy
The message “NO
PLAY” appears on the	The disc is dirty.	Remove the disc and clean it (page 8).
display?
Buttons on the DV-	Power supply voltage fluctuations and other	Turn off the DV-CP701, wait five seconds, then
		turn it on again. If that doesn’t resolve the issue,
CP701 and remote con-	anomalies, such as static electricity, can
		disconnect the power cord from the wall outlet,
troller don’t work?	interfere with normal operation.
		wait five seconds, reconnect it, then try again.
	There are no batteries in the remote	Install new batteries (page 15).
	controller.
	The batteries are flat.	Replace with new batteries (page 15).
	The batteries are installed incorrectly.	Check the batteries and correct as necessary
		(page 15).
	You’re not pointing the remote controller at	Point the remote controller at the DV-CP701’s
Buttons on the DV-	the DV-CP701’s remote sensor.	remote sensor (page 15).
CP701 work OK but
		Use the remote controller closer to the DV-CP701
those on the remote con-
	You’re too far away from the DV-CP701.	(page 15). The remote controller has a range of
troller don’t?
		approximately 16 ft. (5 meters).
	A strong light source is interfering with the	Make sure that the DV-CP701 is not subjected to
		direct sunshine or inverter-type fluorescent lights.
	DV-CP701’s remote sensor.
		Relocate if necessary.
	If the DV-CP701 is installed in a cabinet
	with colored glass doors, the remote control-	Open the doors, or use a cabinet without colored
	ler may not work reliably when the doors are	glass.
	closed.

■Abnormal Behavior

The DV-CP701 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer- ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Alternatively, press and hold the STOP [] button until “RESET” appears on the display (about 10 seconds).

■Restoring the Default Settings

To reset the DV-CP701 to its factory defaults, turn it on and, while holding down the STOP [] button, press the [STANDBY/ ON] button. “INITIALIZE” appears on the display. When the reset is complete, “COMPLETE” is displayed, and the DV- CP701 enters Standby mode.

46