Onkyo DR-S501 instruction manual Hdmi and Progressive Settings, Setting the Hdmi

HDMI and Progressive Settings

HDMI

Note:

Stop playback before perform these settings.

Setting the HDMI

This section explains how to turn on the HDMI OUT and change the video resolution when your TV or projector is connected to the HDMI OUT.

1Press the DVD receiver’s [HDMI]

button to turn on HDMI.

DVD receiver

2Press the [RESOLUTION] button

repeatedly to change the HDMI

Remote controller resolution.

The first button press displays the cur- rent resolution onscreen. Press the but- ton again while the resolution is displayed to change the setting.

The DVD receiver supports the following resolutions:

AUTO:

RESOLUTION

Tip:

These settings can also be changed by using the onscreen setup menus (see pages 60, 61).

Note:

Be sure to choose a resolution that’s supported by your TV. If you select a resolution that your TV doesn’t sup- port, there will be no picture.

Selecting Progressive or Interlaced

If your TV supports progressive video, you can set the DVD receiver to progressive and enjoy progressive video on your TV. If your TV doesn’t support progres- sive video, set the DVD receiver to interlaced.

When HDMI output is at 480p/576p, the component video output is fixed at progressive and depending on the selected resolution there may be no output, so turn off the HDMI OUT before changing this setting.

1Press the DVD receiver’s [HDMI]

button to turn off HDMI.

DVD receiver

The resolution is automatically set to the native resolu- tion of the TV connected to the HDMI OUT.

If the DVD receiver does not support the TV’s native res- olution setting, the resolution 480p/576p will be used.

480p (480p / 576p) (default):

The setting displayed depends on the country in which you purchased the DVD receiver.

720 u 480p 60Hz or 720 u 576p 50Hz

Also output by the DVD receiver’s analog video outputs. With this setting, component video output will be pro- gressive.

720p:

1280 u 720p 50/60Hz

Not output by the DVD receiver’s analog video outputs.

1080i:

1920 u 1080i 50/60Hz

Not output by the DVD receiver’s analog video outputs.

2

Remote controller

Use the [RESOLUTION] button to select “Progressive” or “Inter- lace”.

The first button press displays the cur- rent setting onscreen. Press the button again while the setting is displayed to change the setting.

The PRGSV indicator appears on the display when progressive is selected.

30