Onkyo DR-S501 instruction manual Configuring the DVD receiver

Configuring the DVD receiver—Continued

Speakers Output Balance

Here you can adjust the output balance of speakers. The balance can be adjusted from “L + 12” to “R + 12” in 1 steps.

Note:

When the listening mode is set to “Direct” or “Pure Audio”, no effect will be produced.

Correcting Sound and Picture Sync

When using progressive scanning on your DVD receiver, you may find that the picture and sound are out of sync. With this setting, you can correct this by delaying the audio signals.

•You can set it from 0 to 100 milliseconds (msec) in 20 millisecond steps.

•The setting is available for each input source other than FM and AM.

Note:

When the listening mode is set to “Direct” or “Pure Audio”, no effect will be produced.

Late Night Function (Dolby Digital only)

With the Late Night function, you can reduce the dynamic range of Dolby Digital material so that you can still hear quiet parts even when listening at low volume levels—ideal for watching movies late at night when you don’t want to disturb anyone.

Off: Late Night function off (default). Low: Small reduction in dynamic range. High: Big reduction in dynamic range.

Notes:

•Depending on the design of the contents, there are some materials that will show no effect even when the Late Night mode is operating.

•The Late Night function resets to the default when the DVD receiver is set to Standby.

Display Brightness

You can adjust the brightness of the display.

1:Normal + INPUT selector and MASTER VOLUME light on.

2:Normal + INPUT selector and MASTER VOLUME light off.

3:Dim + INPUT selector and MASTER VOL- UME light off.

4:Dimmer + INPUT selector and MASTER VOLUME light off.

Lock Setup

With this preference, you can protect your settings by locking the setup menus.

When the setup menus are locked, you cannot change any setting.

Locked: Setup menus locked.

Unlocked: Setup menus not locked.

Enabling/Disabling the Subwoofer

This section explains how to specify enabling/disabling the subwoofer.

Yes: Select if a subwoofer is connected. No: Select if no subwoofer is connected.

Front Speakers Size

This section explains how to specify
front speakers sizes.
For speakers with a cone diameter
larger than 16 cm, specify “Large”.
For those with a smaller diameter,
specify “Small”. The crossover fre-	Cone diameter
quency can be changed on page 57.

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Notes:

•If the “Enabling/Disabling the Subwoofer” the above is set to “No”, this setting is fixed at “Large”.

•When the listening mode is set to “Direct” or “Pure Audio”, no effect will be produced.

56