Onkyo DR-S501 Hdmi Status Mode, No picture from the Hdmi connection, Displayed ID Message

Troubleshooting—Continued

HDMI Status Mode

If you’re using an HDMI connection and there’s no picture or sound, you can check the status of the HDMI connection by pressing and holding down the DVD receiver’s [DISPLAY] button for 10 seconds until a message ID appears on the display. Look up the message ID in the following tables and check the HDMI connections and settings on both the DVD receiver and the connected component.

HDMI connection and HDMI-related settings status

	Displayed ID	Message
	MSG ID 001	Turn the DVD receiver and the connected component off, then turn them on again. Make sure that
		the connected component is working properly and that the DVD receiver’s HDMI settings are con-
	MSG ID 015
		figured suitably for that component.
	MSG ID 021	Input is selected other than DVD or VIDEO1. No output from HDMI OUT.
	MSG ID 022	When the DVD or VIDEO1 input is selected, the HDMI Output Setting is set to Off. Change it to On
		(page 30).
	MSG ID 023	Check the settings and connections of the TV and component connected to DVD receiver.
	MSG ID 024	Pure Audio listening mode is selected. Set other listening modes.
No picture from the HDMI connection
	Displayed ID	Message
	MSG ID 002	The “HDMI Output Setting” is set to “Off”. Change it to “On” (page 30).
	MSG ID 003	The HDMI cable may not be connected properly. Check the connection. Also, make sure the HDMI
	MSG ID 004	input on the TV is correctly configured to received HDMI.
		Make sure the HDMI input on the TV is correctly configured to received HDMI.
		The connected component may not support HDCP. Make sure the connected component supports
	MSG ID 005	HDCP.
	MSG ID 006	Turn the DVD receiver and the connected component off, then turn them on again.
	MSG ID 007	The DVD receiver may be connected to the other component’s DVI jack. Some TVs may not prop-
		erly receive the video output by the DVD receiver. Also, with a DVI connection, there will be no
		sound.
	MSG ID 008	The DVD receiver’s “HD Resolution” setting is set to “720p” or “1080i”. If your TV doesn’t support
		these resolutions, select another resolution (page 30).
	MSG ID 009	The connected component may not be receiving the HDMI signal properly.
		Try selecting another resolution on the DVD receiver (page 30).
No sound from the HDMI connection
	Displayed ID	Message
	MSG ID 011	The connected component may not support 96 kHz PCM. Set the DVD receiver’s “Linear PCM
	MSG ID 014	Out” setting to “Down Sample On” (page 62).
	MSG ID 012	The connected component may not support Dolby Digital. Set the DVD receiver’s “Digital/HDMI
	MSG ID 013	Audio Out” setting to “PCM” (page 62).
	MSG ID 016	The connected component may not support DTS. Set the DVD receiver’s “Digital/HDMI Audio Out”
	MSG ID 017	setting to “PCM” (page 62).
	MSG ID 020	Audio from SACDs is not output by the HDMI OUT.

75