Video Output / Setup Menus | English |
Video Output
In order to set up your UNIDISK SC you must first ensure that the unit is outputting the correct video signal type for your display device.
To do this:
●Press and hold DISP (display) on the handset. The current setting for the output video format is shown on the front panel display. To change the video format, press 
or 
. The options available are PAL, NTSC, and Native (for display devices that accept both PAL and NTSC).
●Press DISP again. The current setting for the video scan mode is shown on the front panel display. To change the video scan mode, press 
or 
. The options available are INTERLACED (for display devices that accept an interlaced signal) and PROGRESSIVE (for display devices that accept a progressive signal). If your display device accepts both types, select PROGRESSIVE as this setting provides better picture quality.
After a few seconds the front panel display will change to its previous display.
DVD TV
T U N E R
ALL ONE A - B
DISP DISP
RANDOM SHUFFLE INTRO
GOTO
INCLUDE EXCLUDE RECORD
SURR
ADJUST STORE 
SHIFT
| TV |
|
|
| TITLE |
| DVD |
| SETUP |
| RETURN |
PRESET | TUNE | SCAN | + |
SIGNAL BAND MONO
--+
AUDIO
Setup Menus
About the setup menus
The
The menus are divided into six categories:
General Setup
For configuring the general audio and video setup of the unit.
Speaker Setup
For configuring the unit to the number, size and position of your loudspeakers.
Progressive Scan Setup
For configuring the progressive outputs on the unit, if used.
Video Source Setup
For configuring the video output of the unit.
Audio Setup
For configuring the audio output of the unit.
Preferences
For setting up additional features such as subtitles and parental control. (This category cannot be accessed if there is a disc playing in the unit.)
Note:
The setup menus can be accessed when a disc is playing in the unit (bar the Preferences menus, see above) unless the disc is a
UNIDISK SC PLAYER
7 | Owner’s Manual |