Front Posn. position, Test Tone | Linn UNIDISK SC PLAYER specification

The next menus allow speaker distances to be described to the UNIDISK SC so that the unit can add time delays to certain speakers. This ensures the sound from all the speakers reaches your seating position at the same time.

Front Posn. (position)

Default setting: 1.5 m/5 ft

Calculate the approximate distance between your seating position and your front speakers.

Highlight the 1.5 m/5 ft option then use the key on the handset or front panel to increase the distance shown (up to 9.2 m/30 ft).

Select the appropriate distance by pressing ‘enter’ on the handset or front panel.

Centre Posn. (position)

Default setting: 1.5 m/5 ft

Calculate the approximate distance between your seating position and your centre speaker.

Highlight the 1.5 m/5 ft option then use the key on the handset or front panel to increase the distance shown (up to 9.2 m/30 ft).

Select the appropriate distance by pressing ‘enter’ on the handset or front panel.

Surround Posn. (position)

Default setting: 1.5 m/5 ft

Calculate the approximate distance between your seating position and your surround speakers.

Highlight the 1.5 m/5 ft option. Use the key on the handset or front panel to increase the distance shown (up to 9.2 m/30 ft).

Select the appropriate distance by pressing ‘enter’ on the handset or front panel.

Note:

It is not necessary to set the position for a subwoofer.

Setup Menus

English

Test Tone

For maximum enjoyment of your UNIDISK SC, it is important to ensure that the volume level reaching your seating position is the same for each speaker in your system. Speaker volume trim is adjusted using the unit’s test tone feature.

When set to On, a tone signal is sent to all speakers (except a subwoofer*) starting with the front left and moving in a clockwise direction.

To perform speaker volume trim:

●Set Test Tone to On. The test tone display appears on the UNIDISK SC’s front panel.

●Wait for the test tone to reach the speaker you wish to adjust (your display device and the front panel indicate which speaker the tone is emitting from).

●Repeatedly press or hold VOL - / + on the handset to trim the volume as required.** Volume

trim range is –10 to +10 (in 0.5 steps) with neutral trim being 0.

A few seconds after the VOL - / + key has been released, the test tone will continue its clockwise direction.

To exit speaker volume trim:

●Set Test Tone to Off.

* For subwoofer adjustment– see Subwoofer trim in Pre-amplifierchapter. **You can do this by ear or by using a Sound Pressure Level meter.

UNIDISK SC PLAYER

11	Owner’s Manual