EZQuest DVD Duplication About Buttons, About DVD Writer Not Readable, About High Failure Rate

Page 48

6.4 About Buttons

If you press any one of the four buttons on the panel, but there is no response, it is perhaps that the button cannot function well. Please inspect the jumper setting.

6.5 About DVD Writer Not Readable

After copying if the DVD writer is not readable, please use Compare to examine, or get another DVD-ROM to test.

6.6 About High Failure Rate

If the failure rate of copying is high, please do the following things to improve.

λLower the speed of DVD writer

λInspect if the blank diskís quality is bad.

λUpdate the firmware.

λInspect the DVD writerís maximum writing speed. If the speed is over 24X, copy the data to a hard disk first, and then transmit to DVD.

6.7 About Firmware Update

If you cannot update the firmware, please inspect the BIOS program. Perhaps you have downloaded a wrong program, or let a zipped file be written into DVD. The zipped file should be unzipped first.

Failure in firmware update may cause the copy smart plus to fail in booting. Under the circumstances, please return the control board to ACARD for repair.

Page 48

Image 48

Contents EZQuest Duplicators Copyright and Trademark Buttons and LCD EZQuestDVD Duplicator 1-3 ver 2.03K Initialize Sdram Detect Drives Copy Copy Copying- DVD 0% 4213.4MB d2015Test Copy OKTest Erasing discTesting- DVD 0% 4213.4MB d2015 Test & CopyTest OK Test & CopyVerify Test & Copy OKVerify Verify- DVD 0% 4213.4MBCompare Verify OKCompare Compare- DVD 0% 4213.4MBPrescan Src 01 DVD-ROM Total 4213.4MBSrc 02 DVD-RW Identical Src 02 DVD-RW TOC not matchDisc Info Scaning- DVD 0% 4213.4MBPreScan OK Disc InfoSelect Source Select SourceSrc DVD-ROM 01 IDE1 Master DVD-ROM selectedImage ImageLoad Image LoadImage load OK Image Exists Overwrite?YesDelete Image Image P a Delete ImagePartition a Image is deleted Image InfoImage Image Info Compare ImageTgt 00 HDD P a Identical Tgt 00 HDD P a TOC not matchSelect Partition Image P a Select PartitionSelect Working Partition a Set Partition toEdit Track for CD only Image Image Src DriveSelect Img Src Load image from Drive ID-01Edit Track CD to CDEdit Track CD to CD Edit Select Track 1/10Select Track End 1Trk0325 End edit disc and burn?YesCopying- 24X Edit 1/10 1/1 Burn CompleteContinue edit next Disc?Yes Insert next discSelect Track +2/10 Select Track End 1Trk0425Copying- 24X Edit 2/10 2/2 Continue edit next Disc?NoClose all discís session? Yes Closing Session Please waitCD to HDD Edit Track CD to HDD EditLoad- P0 -24X Edit 1/10 1/1 Continue edit next Disc?Yes Load- P0 -24X Edit 2/10 2/2 Burn or Move to partition?BurnCopy- P0 -24X 0% Trk0325 Burn or Move to partition? Move Moving to P a 0%Moving to P a Play Audio Track Edit Track Play Audio TrackPlaying Track-1 0000 Close SessionEdit Track Close Session Setup SetupClosing Complete Fail Setup Language Setup Burn SpeedLanguage English Burn Speed MaximumSetup Read Speed Setup Auto Start DriveRead Speed Maximum Auto Start Drive OffSetup Startup Menu Setup Auto VerifyStartup Menu 1.Copy Auto Verify OffSetup Auto Compare Setup Auto PrescanAuto Compare Off Auto Prescan OffSetup Eject Disc Setup Burn On The FlyEject Disc Eject Disc Eject Good OnlyBurn Mode Setup Burn ModeNo Valid HDD Setup Button Sound Setup Device InfoButton Sound Device InfoSetup System Info DVD-ROM DVD-116DVD-RW DVR-103 System InfoAdv Setup Adv SetupAdv Setup UnderRun Protect UnderRun ProtectAdv Setup Overburn Adv Setup Read Error SkipRead Error Skip Off Overburn OffAdv Setup Format HDD Adv Setup Verify HDDAll data will be lost, format? Yes There is no HDDAdv Setup Burn-in Verify Disk or Partition? DiskVerify Hard Disk Burn-inUpdate Firmware Adv Setup Update FirmwareSel burn-in num Run Continuous Burn-in Erase&CopyAdv Setup Compare Firmware 12.9 H/W DiagnosticAdv Setup Diagnostic Searching F/WLoad Default Adv Setup Load DefaultLoad Default Config? Yes ≠ ↓ Enter ESC Holde ESC to exitAdv Setup CD+G 12.11 CD+GIsrc About Error Messages About LCDAbout DVD-ROM/DVD Writers About Firmware Update About ButtonsAbout DVD Writer Not Readable About High Failure RateAbout Function 12 and Cancellation Appendix 1 List of Functions Adv Setup Appendix LCD Messages Normal ConditionsConnecting with a HDD Verify Disk or Partition?Firmware Update Audio EditingFirmware is updated successfully