Integra DPC-8.5 instruction manual RS232 port, Ir In/Out

Getting to Know the DPC-8.5—Continued

GRS232 port

This bidirectional RS-232 port can be connected to an external controller.

HAC INLET (26)

The supplied power cord should be connected here.

IOPTICAL DIGITAL AUDIO OUTPUT (24)

This optical digital audio output can be connected to an optical digital audio input on a hi-fi amp, AV receiver, or surround sound decoder (Dolby Digital, DTS). The Digital Out/Digital1 setting on page 56 is used to configure this output.

JCOAXIAL DIGITAL AUDIO OUTPUT (24)

This coaxial digital audio output can be connected to a coaxial digital audio input on a hi-fi amp, AV receiver, or surround sound decoder (Dolby Digital, DTS). The Digital Out/Digital2 setting on page 57 is used to configure this output.

KIR IN/OUT (25)

The IR IN socket can be used to connect a commer- cially available IR receiver, which can be used to pickup signals from the remote controller when the DPC-8.5 is located in another room, installed in a

rack, or is out of range of the remote controller The IR OUT connector can be used to connect a commercially available IR emitter, which can be used to pass remote controller signals received by the IR IN along to other components.

L REMOTE CONTROL (24)

These (Remote Interactive) connectors can be

connected to the connectors on your other Inte- gra AV components for interactive control.

To use you must make an analog audio connec- tion (RCA) between the DPC-8.5 and your Integra AV receiver, even if they are connected digitally.

MCOMPONENT VIDEO OUTPUT 1 (21)

These sockets output component video and can be connected to a component video input on a TV or projector.

NCOMPONENT VIDEO OUTPUT 2 (21)

These sockets output component video and can be connected to a component video input on a TV or projector.

17