Integra DPC-8.5 instruction manual Setting Levels With the Test Tone, AV Synchronization

Configuring the DPC-8.5—Continued

3	When you’ve finished, press the
	[Setup] button to exit setup, or

Remote controller press the Left [] button repeat-

Setup	edly to go back to the main setup
	menu.

Note:

•The Speaker Distance settings have no effect on SACD (multichannel area and 2-channel area) and 196 kHz/176.4 kHz DVD-Audio.

Setting Levels With the Test Tone

4	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select Test Tone, and
	then press the [Enter] button.
	The Test Tone settings appear onscreen.
Enter

6	When you’ve finished, press the
Remote controller	[Setup] button to exit setup, or
	press the Left [ ] button repeat-
Setup
	edly to go back to the main setup
	menu.

AV Synchronization

When using progressive scanning, you may find that the picture and sound are out of sync. With this setting you can delay the audio to correct this. There are three setup memories (1, 2, 3) for storing settings for up to three components. Memories 2 and 3 are already set at 50 ms, which is a good staring point when compensating for the video delay caused by a typical projector with a built-in scaler.

On Standby

5

Remote controller

Enter

Use the Up and Down []/[ ] buttons to select a speaker, press the [Enter] button, use the Left and Right []/[ ] buttons to adjust the level, and then press [Enter] again.

Repeat for each speaker.

A test tone is output by each speaker as it is selected.

Speaker levels can be adjusted in 1 dB steps.

Speaker	Range	Default
Front Left
Center
Front Right	–12 dB to
		0 dB
Surround
	0 dB
Right
Surround Left
Subwoofer

You cannot set the level of speakers that are set to Off.

				Open/
				Close
	Search	Last M	Memory Chain Mode
				Repeat
	1	2	3
				A-B
	4	5	6
				Random
	7	8	9
				Display
	+10	0	Clear
	Top Menu			Menu
Enter		Enter
/
	Return			Setup
	Audio	Angle	Subtitle	Setup
	Stop	Play		Pause
	FR	FF	Down	Up
	Disc 1	Disc 2	Disc 3	Step/Slow
	Disc 4	Disc 5	Disc 6
	Disc Skip	Progressive Dimmer

	RC-543DV
Selecting AV Synchronization
1	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select setup 1, 2, or 3,
	and then press the [Enter] or
	Right [ ] button.
Enter	The parameters appear onscreen.

60