Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on
4 the PDP (Œ) to secure it to the wall mount bracket. (´) Tighten the screws as shown (ˇ) so that the PDP cannot be separated from wall mount bracket.
HPN5039
PDP panel
Wall
Wall attachment panel bracket
HPN6339
PDP panel
Wall
Wall attachment panel bracket
How to Adjust Mounting Angle
Notice : Please secure the mounting bracket on the wall surface after setting its angle at 0°
Factory default
HPN5039 | HPN6339 |
The wall mount bracket is delivered separately.Please tighten the captive screw in the direction of the arrow after assembling the bracket.
Changeing the angle
1 Secure the PDP to the wall mount bracket.(Please refer to the following instructions.)
2 Set the angle by pulling the upper end of the PDP attached to bracket in the direction of the arrow.
3 The angle can be adjusted from 0° to 20° by ±2°.
1.Contact an authorized technician when installing the wall attachment panel.
2.After hanging the PDP panel on the wall attachment panel, make sure that the Insulation holders are completely hung.
3.Be careful so that fingers are not caught.
4.Make sure the wall attachment panel brackets are tightened. Otherwise, the PDP panel may fall down and you might be hurt.
16 | 17 |