Universal Remote Control M2056-C manual Basic Setup Programming Device Control

Page 8

3.Slide the battery door back into place. It should securely fasten to the remote.

4.Test the remote control by pressing any mode key (e.g., TV). If the batteries are inserted correctly, the LED (red light) will blink once.

NOTE: When batteries need replacement, the active mode LED will blink 5 times upon each key- press. Replace the batteries and the unit will be restored to its full functionality, complete with your favorite settings.

BASIC SETUP: PROGRAMMING DEVICE CONTROL

The Titan universal remote control comes pre- programmed to operate the set-top box that is supplied by your service provider. In addition, Titan can be programmed to control four (4) additional home theater equipment devices.

NOTE: If you have another brand of set-top box that you wish to control with the STB key, you'll need to refer to “Re-Programming Set-Top Box Control” on page 22 of this manual.

NOTE: Please read steps 2 through 5 completely before proceeding. Highlight or write down the codes and device you wish to program before moving on to step 2.

1.Turn on all of the devices that you wish to control.

2.On the remote control, press the mode key that you wish to program once (AUX, DVD, AUD,or TV, ); it blinks once.

3.Press and hold SETUP until the mode LED

SETUP blinks twice.

4.Use the “Manufacturer’s Codes” starting on page 25 to locate device type and brand name for the device you wish to control. Enter the first five-digit code for your device. If performed correctly, the mode LED blinks twice.

www.urcsupport.com

8

Image 8
Contents Titan Remote Control Users Guide Table of Contents Features Features and Functions Key Charts Key FunctionKeyFunction Installing Batteries Use PIP ON/OFF to open or close PIP windowBasic Setup Programming Device Control Aim the remote control at the device Searching for Your CodePower once DVD/VCR/DVRChecking the Codes Using LearningLearning Precautions Programming a Learned Key Deleting a Single Learning Key TV, or STBProgramming Volume Lock Locking All Volume Control to a Single DeviceLocking All Channel Control to One Device Unlocking All Volume LocksProgramming Channel Lock Press Setup to save. The mode LED blinks twice Programming Macro Keys Unlocking Channel ControlClearing a Macro Key Programming a Macro KeyVOL+, VOL+, VOL+ Using the Master Power KEY Programming the Master Power KeyUsing the Master Power Key Clearing the Master Power KeyBacklighting Clearing Custom ProgrammingDisabling Backlight Enabling BacklightRE-PROGRAMMING SET-TOP BOX Control Troubleshooting Problem Device mode key does not blink when you press a keyFCC Notice Additional InformationMANUFACTURER’S Codes Setup Codes for Audio AmplifiersSetup Codes for Audio Receivers NAD JBLKLH 31023, 31609 Setup Codes for Audio Accessories Setup Codes for Cable Boxes/ConvertersBBK Setup Codes for Cable/DVR/PVR CombosSetup Codes for DVD Players ESA JSI NECSVA ABS HTS Setup Codes for Satellite Set-Top BoxesGOI AOC CXC Fisher 10154 Fujitsu JCB KDSKEC KTVNTC MGAMTC Philips 11454, 10054 SSS TMK TVSSetup Codes for TVs LCD 10047, 11781 Setup Codes for TVs Plasma Setup Codes for TV/DVD Combos 11963 Setup Codes for TV/VCR Combos Controlled by the VCR Toshiba 20845 Zenith 20000 Hitachi 20000 Howard Computers 21972 Philco 20035 Philips SMC Setup Codes for Video AccessoriesAT&T Page Page M2056-C Revision