Reprogramming your cable device button

Your AllTouch Remote Control is already set up to operate a Scientific- Atlanta home terminal/HCT. If your remote control loses its code for the home terminal/HCT, you need to reprogram your cable device button. Follow the instructions below.

Notes:

•Not all cable functions work with older Scientific-Atlanta home terminals.

•In the cable mode, the VOL button will not control the volume through the home terminal/HCT unless you program it to do so. See Volume Lock on page 14. The Volume Lock defaults to

TV mode.

The code for your brand of home terminal/HCT is 491.

1.Press and release CBL , then hold down SET-UPuntil the red light blinks twice.

Note: You may need to wait a few seconds for the red light to blink twice.

2. Enter 4 9 1 – the red light should blink twice again. (If the red light does not blink twice, return to step 1 and try again.)

3.Point your AllTouch Remote Control at your home terminal/HCT and press POWER .

4.Did your home terminal/HCT turn off (or on)?

•If yes, you are finished setting up your home terminal/HCT.

•If no, go to step 5.

			CBL
	AUX		TV
VCR	POWER			CBL
MENU				INFO
GUIDE				S
GUIDE				T
				E
				L
				E
				C
PPV				FAV
MUTE				L
				T
				AS
	V		C
	O		C
	L		H
A		B		C
1		2		3
4		5		6
7		8		9
PREV. DAY				NEXT DAY

REW PLAY FF

PAUSE STOP REC

SET-UP BYPASS

SET-UP

T6057

Note: All VCR functions ( PLAY ,	FF
mode. To record a program, press	REC

,etc.) also work in CBL twice.

5.If your home terminal/HCT did not respond, repeat steps 1 through 4.

6.If your home terminal/HCT still did not respond, contact your service provider.

573497 Rev B

Reprogramming your cable device button

•If no, go to step 5.

CBL

mode. To record a program, press

REC