Sony KP-61V90, KP-53VGB manual Using the Remote Control, Setting Up the Projection TV Automatically

]]]]]]]]]]]J'lBa icSet Up

Using the Remote Control

Inserting the batteries

Insert two size AA (R6) batteries (supplied)

by matching the + and on the batteries to the diagram inside the remote control's battery compartment.

Notes:

•Remove the batteries to avoid damage from possible battery leakage whenever you anticipate that the remote control will not be used for an extended period.

•Handle the remote control with care.

Avoid dropping it, getting it wet, or placing it in direct sunlight, near a heater or where the humidity is high.

•Your remote control can be programmed to operate most video equipment.

(see "Operating Video Equipment" on page 47)

Setting Up the Projection TV Automatically

The AUTO SET UP feature will allow you to set the on-screen language and set all receivable channels.

The AUTO SET UP feature does not apply for tnstallatians that use a cable box for all channel selection.

You can also set up the wojectian TV manually, (see Using the Channel Set Up menu on pages 30 and 31)

Notes:

•Before you perform AUTO SET LIP again, make sure that the input from ANT (not AUX) is selected By pressing ANT until

"AUX" does not appear next to the channel number.

Perform this function during the day, with the antenna and/or cable properly connected, to ensure that all available

channels wtfl be broadcasting and receivable.

•When you perform AUTO SET UP, all the settings in the Video, and Audio menus are reset to the factory settings.

Using the buttons on the front panel of the

projection TV:

_F_WNIDEQ	--VQLUM_	+	_ _HANN_L+	POWER	m_
[]	[]	[I	[] []	[I	,

1Press POWER to turn on the projection TV.

Press SET UP inside the drop-down panel

on the projection TV and the AUTO SET UP screen appears.

POWER	_rT_4fi_P	:		/_H+]
	F _ arl_ai_	:		/VKaL	+]
	AUtO _i	!Ip	:	[VOL	/
	F_rat pl_a	_n_
	Ih_ anl_mla
	I_	/SEF	UP]	{o _it,

2 Press CHANNEL + to select English,

CHANNEL toselect Espafiol or VOLUME + to select Frangais.

The screen wtfl change to reflect your choice.

--VOLUME ÷ --CHANNEL+ _n_li_P" : ICH _]

Auto 8_1 !1_ : [VOL /

a_na