01COV.book Page 24 Tuesday, July 30, 2002 3:46 PM
Installing and Connecting the Projection TV
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
VIDEO (yellow)
1 Connect the satellite antenna cable to the satellite receiver’s SATELLITE IN jack.
2 Connect the CATV cable to the VCR’s VHF/UHF IN jack.
3 Using a coaxial cable, connect the VCR’s OUT jack to the projection TV’s VHF/UHF jack.
4 Using AUDIO and S VIDEO cables, connect the satellite receiver’s AUDIO and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO IN jacks.
5 Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Rear of projection TV
| Satellite |
| antenna |
Satellite receiver | cable |
|
Coaxial cable
(not supplied) | 820S (not |
| supplied) |
S VIDEO |
|
VCR |
|
Cable
|
|
| ||
(not supplied) |
|
|
| |
|
|
|
|
✍Be sure your VCR’s video input is set correctly. Consult your VCR’s operating manual for instructions.
✍Use TV/VIDEO to select
-VIDEO 1 to watch satellite TV or the VCR (your VCR must be turned on).
-VHF/UHF to watch cable TV.
✍If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.
24
Model