Sony KP-65WS500, KP-51WS500, KP-57WS500, KP-46WT500 manual Connecting a Digital TV Receiver

01COV.book Page 28 Tuesday, July 30, 2002 3:46 PM

Installing and Connecting the Projection TV

Connecting a Digital TV Receiver

zBe sure to read the Set-top box manual.

zSome Digital TV Receivers are equipped with a DVI connection. Refer to your Digital TV Receiver manual for setup instructions using this connection.

Disconnect all power sources before making any connections.

1 Using three separate component video cables, connect the Digital TV Set-top box’s Y, PB and PR jacks to the projection TV.

✍The Y, PB and PR jacks do not provide audio, so audio cables must be connected to provide sound.

✍Component video connection is necessary to view 480p, 720p, and 1080i formats. You may also use the S VIDEO or Composite Video connections, however, component video (Y, PB, PR) will provide the best picture quality for all format types.

2 Using an audio cable, connect the Digital TV Set-top box’s Audio OUT jacks to the projection TV’s AUDIO IN jacks.

Rear of projection TV

	PR
VMC-10HG (not supplied)	PB
	Y
Digital TV Set-top box
	AUDIO-R (red)
	AUDIO-L (white)

RK-74A (not supplied)

✍You cannot record the signal from any equipment connected into the Y, PB and PR connectors.

✍This projection TV is not compatible with digital TV receivers configured with RGB or VGA output connectors.

✍The DVI connection is compliant with the EIA-861 standard and is not intended for use with personal computers.

28

Model name1[KP-46WT500] Model name2[KP-51WS500] Model name3[KP-57WS500] Model name4[KP-65WS500]

[4-088-847-12]