Pioneer BDP-V6000 operating instructions Others

09

Others

Problem

Check

Remedy

Player cannot be restored to

Is a disc loaded in the player?

Remove the disc from the player before restoring the player to the

the factory defaults.

factory defaults (page 51).

Player cannot be controlled

Check the Advanced Setup  Baud Rate setting and the serial

by RS-232C.

interface specifications (page 56 and 58).

The player’s power turns off

Is Auto Power Off set to

If Auto Power Off is set to On, the player’s power turns off

automatically.

On?

automatically if no operation is performed for over 30 minutes

(page 46).

The player’s power turns on

Is KURO LINK set to On?

The player’s power may turn on together with the power of the TV

automatically.

connected to the HDMI OUT terminal. If you do not want the player’s

power to turn on when the TV’s power is turned on, set KURO LINK to

Off (page 44).

Player cannot be operated

Is an AV receiver or amplifier

Operate with the remote control of the device connected to the

with remote control.

connected to the CONTROL

CONTROL IN terminal.

IN terminal on the player’s

rear panel?

Are you operating the remote

Operate from within 23 feet (7 m) of the remote control sensor.

control from a point too far

away from the player?

Are the batteries dead?

Replace the batteries (page 7).

Is the RC-232C Key Lock

Cancel the Key Lock command. For details, see the communications

command set?

interface user's manual.

Black screen is displayed

Is Screen Saver set to On?

• The screensaver turns off when the player’s front panel or remote

though no operations are

control is operated.

being performed.

• If you do not want the screensaver to be activated, set Screen Saver

to Off (page 46).

Front panel display does not

Has the front panel display

Press FL DIMMER on the remote control to switch the front panel

turn on.

been turned off?

display’s brightness (page 12).

Buttons on the player's front

Is Front Key Lock set to All

Set Front Key Lock to Off (page 55).

panel cannot be operated or

or Tray?

the disc tray does not open.

Input of connected TV and AV

Is KURO LINK set to On?

The input of the TV and AV system (AV receiver or amplifier, etc.)

system switches

connected to the HDMI OUT terminal may automatically switch to the

automatically.

player when playback starts on the player or the menu screen (Home

Media Gallery, etc.) is displayed. If you do not want the inputs of the

connected TV and AV system (AV receiver or amplifier, etc.) to switch

automatically, set KURO LINK to Off (page 44).

“Processing failed.” is

If the message appears repeatedly, please ask your nearest Pioneer

displayed.

authorized service center or your dealer to carry out repair work.

Settings you have made have

• Have you disconnected the

Always press  STANDBY/ON on the player’s front panel or

been cleared.

power cord while the player’s

 STANDBY/ON on the remote control and check that POWER OFF

power was on?

has turned off from the player’s front panel display before

• Has there been a power

disconnecting the power cord. Be particularly careful when the power

failure?

cord is connected to the AC outlet on another device because the

player turns off in conjunction with the device.