PLAYBACK
Rapid Playback
This function plays back approximately at 1.3 times the normal playback while keeping the sound output. This function is available only on discs recorded in the Dolby Digital format.
1During playback, press [MODE] repeatedly until the Rapid playback setting appears.
Off
2Press [ENTER] or [s / B] to switch (1.3x), or off.
“Off” : Plays back in normal speed.
“” : Plays back approximately at 1.3 times of normal playback.
3Press [PLAY B] to return to normal playback.
Note
•Picture adjustment and audio language setting cannot be changed during this function.
•Virtual surround does not work during this function.
•This function may not work at some points on a disc.
•During this function, 2ch LPCM will be output from HDMI OUT jack and DIGITAL OUT jack.
Adjusting the Picture
You can adjust the picture quality.
1During playback, press [MODE] repeatedly
until appears.
2Use [K / L] to select your desired item, then use [s / B] to adjust the setting.
|
| Black Level | On |
|
| Noise Reduction | Off |
|
|
|
|
e.g.)
S Black level
You can adjust the black level setting to make the black parts of the pictures as bright as you prefer. You can select “On” or “Off”.
“On” :Enhances detail in darker areas.
“Off” :Shows the original picture as recorded.
SNoise reduction (DVD-video only)
Reduces the noise of the playback picture.
“Off” :Shows the original picture as recorded.
“1” :Executes 3D noise reduction which detects and deletes the noise by comparing each picture frames.
“2” :Executes MPEG noise reduction which reduces the block noise and mosquito noise on the subtitles on the movie.
“3” :Executes both MPEG noise reduction and 3D noise reduction.
3Press [RETURN] to exit.
Note
•The setting will remain the same even if the unit is turned to the standby mode.
•“Black Level” is not effective under the following conditions.
-When the picture is output from HDMI OUT jack.
-When the picture is output from COMPONENT VIDEO OUT jack with “Component Output” set to “480p / 720p / 1080i”.
•You cannot adjust the setting during rapid playback.
Virtual Surround
You can enjoy stereophonic virtual space through your existing 2 channel stereo system.
1During playback, press [MODE].
2Use [K / L] to select your desired setting.
Off
“Off” :No surround effect “1” :Natural surround effect “2” :Stronger surround effect
3Press [RETURN] to exit.
Note
•Set the virtual surround setting to “Off” or lower the volume if the sound is distorted.
•Virtual surround does not function during rapid playback.
•For the virtual surround, audio signal will always be
28 | EN |