Sony SX-MT321 II SET within 6 seconds, Press Function to select a source, then press, Ii Set, ~ w

2,4

1,2,3,4

The unit can be turned on at a specified time every day with the

built-in timer.

Preparation

Make sure the clock is set correctly.

1 Press TIMER repeatedly to display 0, then press

IISET within 6 seconds.

@is displayed and the hour flashes.

?

m

If you press II SET after 6 seconds, another operation may start.

2 Designate the hour of the timer-on time by

pressing + DOWN or B UP, then press II SET.

Repeat to designate the minute of the timer-on time.

After you designate the timer-on time, one of the source names

flashes on the display.

3 Press FUNCTION to select a source, then press

IISET.

●If TUNER is selected, the band cannot be selected in this step.

4 Select the duration for the timer-activated period

with ++ DOWN or - UP, then press 11 SET.

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

5 Prepare the source.

To listen to a CD, load the CD to be played first on tray 1. To listen to a ta~e, insert the tape into deck 1 or 2.

To listen to the radio, tune in to a station.

6 Press POWER to turn the unit off after adju!~ting the volume and tone.

@remains on the display after the power is turned off (timer standby mode).

When the timer-on time is reached, the unit turns on and begins play with the selected source.

The volume level is automatically set to 20 when the power is turned off with the volume level set to 21 or more.

To check the specified time and source

Press TIMER, The timer-on time, the selected source name and

the duration for the timer-activated ~eriod are displayed,. for 4 seconds,

To cancel timer standby mode temporarily

Press TIMER repeatedly until 0 disappears on the display.

To restore the timer standby mode, press TIMER repeatedly to display ~.

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

●Timer playback and timer recording will not begin unless the power is turned off.

“Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

‘ MULTI JOG is also available instead of H and FF

Timer recording is applicable for TUNER and VI DEO/AUX (wilh an external timer) sources only.

Press TIMER repeatedly until O flashes on the display, therr

press II SET within 6 seconds. Carry out the steps of “SETTING THE TIMER from step 2 and insert the tape to be recorded on into deck 2 after step 5.

~J,,

;:gj

#

i

$%

&@l

L@&:

$$$:,

‘iw’

j~: w

G

ENGLISH20