Viper G5102V manual Transmitter configuration, Aux

Page 14

➤Transmitter configuration

Level

Button

Direct Access

x 1

x 2

x 3

x 4

	Arm/Lock	Silent Arm	Sensor	Silent Alarm	Silent Alarm
	(Panic)		Bypass **	Sensors †	All Zones †
	Disarm/Unlock	Silent Disarm	Valet On/	Car Finder
	(Panic)		Off
	Starter	Reset	Timer Mode	Smart Start	Defogger
	On/Off	Runtime	On/Off	On/Off	On
A U X	Trunk Release	AUX 1	AUX 2	AUX 3	***
	(Red/White)
	Advance Level	Request	Runtime	Event His-
	Change Car	Temperature	Remaining	tory Report
	(3s) Enter	* †	* †	* †
	programming
	(8s) *

* button must be pressed and held to access state

**System must be in ARMED mode to access this feature

***System must be in remote start mode to access this feature

† Only applicable when upgrading to two way remote

Note: Pressing more than one button simultaneously generates an Error tone and the LED flashes.

14	© 2008 Directed Electronics. All rights reserved.

Image 14

Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Important information What is includedYour warranty Low battery indicator Replacement remotesSystem maintenance Battery ReplacementTo change the car selection Feature Description Way remoteTransmitter configuration AUXFeature List Aux Runtime resetValet mode Sensor BypassSmart start Timer modeCar finder DefoggerWhile the system is armed Using the systemArming the system Directed Electronics. All rights reserved Modified Arming Modes Disarming the System While the system is armed normallyValet mode System overrideTo configure the remote control features Remote feature programmingTo program the remote user features Panic mode Remote Beeps featurePoints to remember Using the remote startRemote starting your vehicle Manual transmission vehicles To drive your vehicle after it has been remote startedTimer mode To activate timer mode with an automatic transmissionTurbo timer mode Smart start To activate Smart Start modeTo activate Smart Start mode with a manual transmission Use one of the below methods to exit Smart Start mode Turning on the rear defoggerValet take-over Disabling the remote start system Safety featuresStarter anti-grind circuitry Diagnostics ArmingTable of zones DisarmingSystem status chirps Interpreting zone diagnostics Nuisance prevention circuitryDirected Electronics. All rights reserved Owner recognition Rapid resume logicPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics