Viper G5102V manual Directed Electronics. All rights reserved

Page 36

interpret those triggers as false alarms. After the third trigger, NPC ig- nores, or bypasses, that sensor or switch (along with any other sensors or switches sharing the same zone) for 60 minutes.

If the bypassed sensor tries to trigger the security system while it is being bypassed, the 60-minute bypass period will start over. This ensures that a sensor that is continually being triggered will remain bypassed.

The vehicle doors are protected by NPC differently. If your security system is triggered by an open door for three full cycles, the system will bypass the doors until the trigger ceases.

NPC requires that you change the way you test the system since NPC bypasses an input zone for 60 minutes. If the system “sees” the same zone trigger three times, and the triggers are spaced less than an hour apart, the system bypasses that input zone for 60 minutes.

If that zone does not attempt to trigger the system during the 60-minute bypass period, the zone’s monitoring begins again at the end of the hour. If it does attempt to trigger while bypassed, the 60-minute bypass starts over again.

Disarming and rearming the system does not reset NPC. The only way to reset NPC™ is for the 60 minutes to pass without a trigger, or for the ignition to be turned on. This allows the system to be repeatedly triggered, disarmed and rearmed, and still allows NPC to bypass a faulty zone.

When disarming the system, 5 chirps indicate NPC is activated. The LED reports the zone that has been bypassed. (See Diagnostics section of this guide.)

36

© 2008 Directed Electronics. All rights reserved.

Image 36
Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved What is included Your warrantyImportant information Replacement remotes System maintenanceLow battery indicator Battery ReplacementTo change the car selection Feature Description Way remoteTransmitter configuration AUXFeature List Runtime reset Valet modeAux Sensor BypassTimer mode Car finderSmart start DefoggerUsing the system Arming the systemWhile the system is armed Directed Electronics. All rights reserved Modified Arming Modes Disarming the System While the system is armed normallyValet mode System overrideRemote feature programming To program the remote user featuresTo configure the remote control features Panic mode Remote Beeps featureUsing the remote start Remote starting your vehiclePoints to remember Manual transmission vehicles To drive your vehicle after it has been remote startedTimer mode To activate timer mode with an automatic transmissionTurbo timer mode To activate Smart Start mode To activate Smart Start mode with a manual transmissionSmart start Use one of the below methods to exit Smart Start mode Turning on the rear defoggerValet take-over Safety features Starter anti-grind circuitryDisabling the remote start system Diagnostics ArmingDisarming System status chirpsTable of zones Interpreting zone diagnostics Nuisance prevention circuitryDirected Electronics. All rights reserved Owner recognition Rapid resume logicPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics