Viper G5102V manual Turbo timer mode

Page 28

Note: The Bitwriter can change the amount of times the remote start activates and, it can change the intervals between activations in timer mode.

Turbo timer mode

Turbo timer mode keeps the engine running after arriving at your desti- nation for a programmable period of 1, 3, 5 or 10 minutes. This allows the system’s timer to conveniently cool down the turbo after you have left the vehicle.

To activate Turbo Timer Mode with an automatic transmission:

1.Make sure the Turbo timer feature is turned on in the features grid.

2.Open the vehicle door.

3.While the vehicle is running; press the button twice followed

by the button.

4.The parking lights flash once.

5.Turn off the ignition (car stays running).

6.Exit the vehicle and arm the system.

At this point the vehicle stays running for the programmed runtime.

To activate turbo timer mode with a manual transmission:

Perform the procedure for manual transmission vehicles (page 26), with the door open. Transmit the timer mode feature with the remote by pressing two-times, and then . After exiting the vehicle, lock the system and the vehicle remains running for the programmed runtime. (The remote start feature is still enabled).

You can still remote start the vehicle after the turbo timer has timed out and shut off the vehicle. For safety reasons, if a door is opened (while the alarm is armed or disarmed) or if the alarm is triggered while you are away, the remote start exits the manual transmission mode and

28

© 2008 Directed Electronics. All rights reserved.

Image 28
Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Your warranty What is includedImportant information Replacement remotes System maintenanceLow battery indicator Battery ReplacementTo change the car selection Feature Description Way remoteTransmitter configuration AUXFeature List Runtime reset Valet modeAux Sensor BypassTimer mode Car finderSmart start DefoggerArming the system Using the systemWhile the system is armed Directed Electronics. All rights reserved Modified Arming Modes Disarming the System While the system is armed normallyValet mode System overrideTo program the remote user features Remote feature programmingTo configure the remote control features Panic mode Remote Beeps featureRemote starting your vehicle Using the remote startPoints to remember Manual transmission vehicles To drive your vehicle after it has been remote startedTimer mode To activate timer mode with an automatic transmissionTurbo timer mode To activate Smart Start mode with a manual transmission To activate Smart Start modeSmart start Use one of the below methods to exit Smart Start mode Turning on the rear defoggerValet take-over Starter anti-grind circuitry Safety featuresDisabling the remote start system Diagnostics ArmingSystem status chirps DisarmingTable of zones Interpreting zone diagnostics Nuisance prevention circuitryDirected Electronics. All rights reserved Owner recognition Rapid resume logicPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics