Viper G5102V manual Using the system, Arming the system, While the system is armed

Page 18

Using the system

Arming the system

To arm the system, press the button on the remote control.

The siren in the vehicle will “chirp” once and the parking lights will flash once. If the power door locks have been connected, the doors will lock. The system will automatically check for errors when it arms.

If errors are found when arming:

If an alarm trigger zone – such as a door, the trunk, the hood, or a sensor, was active at the time of arming, the system will “bypass”, or ignore, this trigger zone. This allows the system to continue to protect your vehicle using the remaining trigger zones.

You are notified of this active zone immediately after arming the system. The siren in the vehicle will “chirp” again and the parking lights will flash again. The Status LED indicator in the vehicle will blink in a pattern to indicate the active zone number error which was found (See Table of Zones on page 34).

Arming without the chirp (Silent Arm):

Press the button at the bottom of the remote once, and then press the button. The system will arm without the confirmation chirp. The parking lights will flash once.

While the system is armed

Fail-Safe Starter Kill

The starter is disabled by the system’s Fail-Safe starter kill (if installed).

18

© 2008 Directed Electronics. All rights reserved.

Image 18
Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved What is included Your warrantyImportant information Low battery indicator Replacement remotesSystem maintenance Battery ReplacementTo change the car selection Feature Description Way remoteTransmitter configuration AUXFeature List Aux Runtime resetValet mode Sensor BypassSmart start Timer modeCar finder DefoggerUsing the system Arming the systemWhile the system is armed Directed Electronics. All rights reserved Modified Arming Modes Disarming the System While the system is armed normallyValet mode System overrideRemote feature programming To program the remote user featuresTo configure the remote control features Panic mode Remote Beeps featureUsing the remote start Remote starting your vehiclePoints to remember Manual transmission vehicles To drive your vehicle after it has been remote startedTimer mode To activate timer mode with an automatic transmissionTurbo timer mode To activate Smart Start mode To activate Smart Start mode with a manual transmissionSmart start Use one of the below methods to exit Smart Start mode Turning on the rear defoggerValet take-over Safety features Starter anti-grind circuitryDisabling the remote start system Diagnostics ArmingDisarming System status chirpsTable of zones Interpreting zone diagnostics Nuisance prevention circuitryDirected Electronics. All rights reserved Owner recognition Rapid resume logicPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics