Viper G5102V manual System override, Valet mode

Page 22

High-Security Disarming

If you want the Full Alarm response to stop without unlocking the doors, press the button. The system will re-arm and the current alarm re- sponse will reset.

➤System override

To disarm the system without a remote control:

You will need to use your Override Switch located on your systems control center (see diagram to left) to disarm the system. The Override Switch disarms the system only if you have the vehicle key.

•Open the door. The alarm will sound.

Immediately insert the key into the ignition and turn it to the RUN or ON position. (all the indicators in the dash will turn on).

Press the Override Switch once.

Note: The Override Switch feature allows you to select a specific number of presses needed to disarm the alarm. If the Override Switch has been programmed to a new number of presses by your authorized dealer, that number should be indicated below.

Override Switch Number ___________

➤Valet mode

To enter or exit valet mode with the valet/program switch:

Turn the ignition key on and then off.

22	© 2008 Directed Electronics. All rights reserved.

Image 22

Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Your warranty What is includedImportant information Low battery indicator Replacement remotesSystem maintenance Battery ReplacementTo change the car selection Feature Description Way remoteTransmitter configuration AUXFeature List Aux Runtime resetValet mode Sensor BypassSmart start Timer modeCar finder DefoggerArming the system Using the systemWhile the system is armed Directed Electronics. All rights reserved Modified Arming Modes Disarming the System While the system is armed normallyValet mode System overrideTo program the remote user features Remote feature programmingTo configure the remote control features Panic mode Remote Beeps featureRemote starting your vehicle Using the remote startPoints to remember Manual transmission vehicles To drive your vehicle after it has been remote startedTimer mode To activate timer mode with an automatic transmissionTurbo timer mode To activate Smart Start mode with a manual transmission To activate Smart Start modeSmart start Use one of the below methods to exit Smart Start mode Turning on the rear defoggerValet take-over Starter anti-grind circuitry Safety featuresDisabling the remote start system Diagnostics ArmingSystem status chirps DisarmingTable of zones Interpreting zone diagnostics Nuisance prevention circuitryDirected Electronics. All rights reserved Owner recognition Rapid resume logicPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics