does not remote start until the MTS sequence is
Note: An optional push button can be hard wired to the
When the vehicle is running follow the procedures listed above, but instead of pressing the remote, press the push button the appropriate number of times to activate the remote start (factory setting is for 1 pulse). Turn off the ignition and exit the vehicle. The car remains running for the
➤Smart start
With Smart Start you can activate remote start when the vehicle reaches a certain temperature, or when it reaches a certain voltage.
The factory setting for temperature high is 100º, and the low is 0º (F). The voltage setting is 10.5v. These settings can be adjusted or turned off by your installer using the Bitwriter.
To activate Smart Start mode:
•Press the button on the remote 3 times and then press the button.
The parking lights flash 5 times fast to confirm the remote is in Smart Start mode.
To activate Smart Start mode with a manual transmission:
1.Enter the MTS procedure.
© 2008 Directed Electronics. All rights reserved. | 29 |