Universal Electronics ATLAS OCAP manual Programming a Learned Key

Atlas OCAP M1056L.fm Page 15 Friday, December 22, 2006 6:10 PM

•Learning capacity is approximately 16 to 25 keys, depending on the code being learned.

•Certain device functions are not learnable including multi-frequency types, some high frequency ones, and other unusual formats.

•For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights.

NOTE: Please have your original remote controls handy before programming learning.

Programming a Learned Key

NOTE: If more than 15 seconds pass between key presses, the remote exits programming.

1.Press and hold SETUP until the last-selected

mode key blinks twice, then press 9 7 5.

NOTE: If the LED displays one long flash instead, either your batteries are low, or the Atlas OCAP 5-Device Remote Control with Learn- ing has a memory fault.

2.Press a mode key once (i.e., VCR, DVD, AUD,

TV, or CBL) to assign a mode for learning.

3.Then press the key on your Atlas OCAP Remote Control that learns the new code.

4.Place the Atlas OCAP 5-Device Remote Control with Learning head-to-head (about 2" apart) from your original remote control. Also locate the key (on your original remote control) that you want the Atlas OCAP 5- Device Remote Control with Learning to learn.

2"

5.On the original remote, press and hold the key to be learned. The Atlas OCAP 5-Device Remote Control with Learning’s LED will blink rapidly, then turn off. Continue holding

www.urcsupport.com/atlasocap

15