Universal Electronics ATLAS OCAP manual Changing Volume Lock, Locking Channel Control to CBL

Atlas OCAP M1056L.fm Page 18 Friday, December 22, 2006 6:10 PM

Locking Channel Control to CBL

1.On the remote control, press CBL once; it will blink once. Press and hold SETUP until the

CBL key blinks twice.

2.Enter 9 7 3.The CBL key will blink twice.

3.Press CH+ once. The CBL key will blink twice.

Now, regardless of what mode you select (except AUD), the channel keys will only change channels on your cable converter.

CHANGING VOLUME LOCK

Volume Lock allows you to control the volume through the device identified as having your primary speaker(s), regardless of which mode you are using. On the Atlas OCAP 5-Device Remote Control with Learning, Global Volume Lock is set to TV, so you can control TV volume while in the VCR, DVD, TV or CBL mode. You can perform Individual Volume Unlock on a selected device to set its volume control for independent operation.

NOTE: The audio mode’s (AUD) volume controls are active regardless of Volume Lock settings. However, if you lock the volume controls to the AUD mode, you will have control of the audio device’s volume in all other modes (i.e., VCR, DVD, TV, and CBL). This can be an advan- tage if, for example, you always listen to home entertainment devices through your receiver’s speakers.

Unlocking Volume Control for a Single Device (Individual Volume Unlock)

1.Assuming Global Volume Lock is active, select a mode on the remote control that you want to

unlock (e.g., CBL) and press it once. Next, press and hold SETUP until the device key blinks twice.

2.Enter 9 9 3. The last-selected device key will blink twice.

www.urcsupport.com/atlasocap

18