Universal Electronics ATLAS OCAP manual RE-ASSIGNING Device Keys, Using the Master Power Key

Atlas OCAP M1056L.fm Page 23 Friday, December 22, 2006 6:10 PM

Using the Master Power Key

1.After programming, point the remote control

at the devices. Press CBL once.

2.Press PWR once to sequentially turn the

programmed home entertainment devices on or off.

You will see the devices turn on or off according to the programmed sequence.

Clearing the Master Power Key

1.On the remote control, press and hold SETUP

until the last-selected device key blinks twice.

2.Enter 9 9 5. The last-selected device key blinks twice.

3.Press and release PWR.

4.Press and hold SETUP until the CBL key blinks twice.

RE-ASSIGNING DEVICE KEYS

The Atlas OCAP 5-Device Remote Control with Learning can be set up to control a second device of an already- assigned type. For example, to have the unit control a TV, a Cable Converter, and two audio devices (for example, two audio receivers), re-assign the unused VCR key to operate the second audio device as follows:

NOTE:	VCR is preset at the factory to control an RCA
	VCR. Performing the steps below will over-
	write those settings.

1.On the remote control, press VCR once; it will blink once. Then press and hold SETUP until

the VCR key blinks twice.

2.Enter 9 9 2. The VCR key will blink twice.

www.urcsupport.com/atlasocap

23