Universal Electronics Comprehensive Guide to Atlas OCAP Remote Programming | URCSupport

presses, the remote exits programming.

If more than 15 seconds pass between key

Atlas OCAP M1056L.fm Page 17 Friday, December 22, 2006 6:10 PM

Deleting All Learned Keys in a Specific Mode NOTE:

1.	Press and hold SETUP until the last-selected
	mode key blinks twice, then press 9 7 5.

2.	Press a mode key twice (i.e., VCR, DVD, AUD,
	TV, or CBL) to clear all the learned keys for
	that mode. The LED blinks twice.

3.	Repeat step 2 for another mode or press and
	hold SETUP to exit programming.

PROGRAMMING CHANNEL CONTROL LOCK

By default, the remote control’s channel-control capabilities are locked to the cable converter. The affected keys* are 1 through 0, CH+, CH-, and LAST. This will guarantee that you do not inadvertently change a channel on your TV or VCR. However, you can de- activate this feature to allow full access to these keys in the TV and VCR modes.

*NOTE: This feature does not affect the AUD mode.

Unlocking Channel Control

1.On the remote control, press CBL once; it will

blink once. Press and hold SETUP until the CBL key blinks twice.

2.Enter 9 7 3. The CBL key will blink twice.

3.Press CH- once. The CBL key will blink four times.

Now the remote control will provide TV and VCR channel-control capabilities while in the TV or VCR mode.

www.urcsupport.com/atlasocap

17